Cardone 26-3031 Rack and Pinion Assembly

Cardone 26-3031 Rack and Pinion for Infiniti FX35/FX45

Cardone 26-3031 is a remanufactured electronic power steering rack and pinion assembly built for 2004-2008 Infiniti FX35 and FX45 applications. It is rebuilt with new premium components, tested under simulated driving conditions, and finished for corrosion resistance to support consistent steering response.

Key Features

• Remanufactured Original Equipment-style fit for Infiniti FX35 and Infiniti FX45
• New rubber sealing components installed to help reduce internal leakage
• Specialized lubricant applied for extended service life
• Factory test drive verifies operation under demanding conditions and on-car communications
• Protective coating helps resist rust and corrosion
• Steel and aluminum construction with tie rod ends included
• Banjo/washer hose ports with M14 x 1.5 pressure port and M16 x 1.5 return port

Product Details

This Cardone Rack and Pinion Assembly, part number 26-3031, is engineered for direct replacement on 2004-2008 Infiniti FX35 and 2004-2008 Infiniti FX45 models. The remanufacturing process replaces all rubber sealing components, installs new spool valve seals and rack donut seals where applicable, and uses polished micro-finish sleeves in the valve housing where applicable to support durability. The assembly measures 46.63 inches in rack length, has 4 mounting holes, a 0.75-inch input shaft diameter, and 2.75 total turns lock to lock.

Cardone’s electronic power steering rack and pinion line focuses on restoring OE-level steering feel with verified communication checks during testing. For shoppers searching for a remanufactured Infiniti FX35 steering rack, Infiniti FX45 rack and pinion assembly, or Cardone 26-3031 replacement steering gear, this unit is built around the original vehicle fit and steering system requirements.

This part cross-references Infiniti 49001CG101 and 49001CL10A for the same application.

Common Issues This Part May Address

• Steering effort that is hard during the first few minutes of driving
• Internal hydraulic leakage in the steering rack
• Power steering pump noise caused by air in the system after service
• Steering that does not return to center after a turn
• Wear-related “morning sickness” symptoms from internal bypass in the rack housing

Installation Notes and Tips

Fits 2004-2008 Infiniti FX35, N/A. Fits 2004-2008 Infiniti FX45, N/A. Install an in-line filter and use OE fluid. Flush the hydraulic power system when installing the rack and pinion assembly with inner tie rods for warranty validation. Bleed the steering system completely after installation to remove air and reduce pump whine. If the steering does not return to center, check front-end alignment and inspect the return line for restriction or kinks.

Quality Assurance

Each Cardone 26-3031 rack and pinion assembly undergoes a factory test drive that simulates extreme operating conditions while checking on-car communications. The remanufacturing process reduces the energy and raw materials needed versus producing a new part, and the finished unit is protected with a coating to help prevent corrosion and rust.