Cardone 30-2892MB Distributor

Remanufactured Distributor for Ford 5.0L V8 Applications

The Cardone 30-2892MB remanufactured distributor is built for 8-cylinder ignition systems that require accurate spark timing and dependable voltage delivery to the spark plugs. It is a Hall Effect distributor with the electronic module supplied, making it a direct replacement choice for select Ford, Lincoln, and Mercury vehicles from the mid-1980s through the early 1990s.

Cardone’s Distributor line focuses on remanufactured ignition components that restore proper timing control and consistent engine operation. This part number, 30-2892MB, is intended for vehicles that use the specified steel gear configuration and module-equipped electronic distributor design.

Key Features

• Remanufactured distributor for 8-cylinder applications
• Hall Effect distributor design
• Electronic module supplied
• 100% new points and condensers installed where applicable
• All electronic module components are computer tested for functionality
• Automated test equipment verifies signal strength, polarity, air gap, reluctor tooth size, and ignition performance
• Meets or exceeds O.E.M. performance requirements
• Precise machining tolerances help prevent oil leakage, timing issues, and premature failure
• Guaranteed fit and function

Detailed Description

Cardone 30-2892MB is a remanufactured ignition distributor engineered to restore proper spark timing in select Ford, Lincoln, and Mercury V8 vehicles. It is built with a Hall Effect design and supplied with the electronic module, helping maintain the correct timing pattern needed for stable engine performance. The distributor is gray in color, does not include a coil wire, cap, rotor, or integrated ignition coil, and is listed as a remanufactured product.

Compatible With 1986 Ford LTD, 1986-1990 Lincoln Town Car, 1986-1991 Mercury Grand Marquis, 1987-1991 Ford LTD Crown Victoria, 1987-1991 Mercury Colony Park, and 1987-1992 Lincoln Mark VII, with steel gear applications. Use of the correct distributor part number is important because cast iron and steel gears are not interchangeable.

This part cross-references Ford E6AE12127DA and E6AZ12127D for the same application.

What This Distributor Helps Address

• Hard starting caused by weak or inconsistent ignition timing
• Misfire conditions related to distributor signal or module failure
• Rough idle from worn internal distributor components
• Check engine light concerns tied to timing or ignition signal errors
• Oil leakage or premature wear from poor machining tolerances

Installation Notes and Tips

• Verify steel gear application before installation; cast iron and steel gears are not interchangeable.
• Confirm the vehicle uses the correct electronic distributor configuration with module supplied.
• Transfer or source any components not included, such as the cap, rotor, coil wire, or ignition coil.
• Set ignition timing according to the vehicle service procedure after installation.
• Inspect the camshaft and distributor gear condition before installing the replacement unit.

Quality Assurance

Cardone remanufactures this distributor under stringent quality standards and tests electronic components to confirm proper operation. Automated verification checks signal strength, harness polarity, air gap, reluctor tooth size, and ignition coil and pickup performance to support reliable fit and function.