Cardone 31-1011 Distributor

Remanufactured Distributor for Reliable Ignition Timing

The Cardone 31-1011 remanufactured distributor is built to restore proper spark timing and voltage delivery to the spark plugs. It is a magnetic coil distributor with an electronic module supplied, making it a practical replacement for select 4-cylinder applications, including Nissan 22100D3315 interchange coverage.

Cardone Distributor 31-1011 is remanufactured under strict quality standards and is intended for drivers who need consistent ignition performance from a direct-fit distributor replacement. For Nissan distributor replacement needs, this part is focused on fit and function with tested electronic components and precise machining.

Key Features

• Remanufactured distributor for 4-cylinder applications
• Magnetic coil distributor type
• Electronic module supplied
• 100% new points and condensers installed where applicable
• All electronic module components are computer tested for functionality
• Automated test equipment checks signal strength, polarity, air gap, reluctor tooth size, ignition coil, and pickup performance
• Meets or exceeds O.E.M. performance targets
• Precise machining tolerances help prevent oil leakage, timing issues, and premature failure
• Gray finish

Product Details

The Cardone Distributor line focuses on remanufactured ignition components that restore dependable engine operation without unnecessary complexity. Part number 31-1011 is engineered for proper voltage transmission and correct timing pattern at the spark plugs, helping maintain stable ignition performance in compatible Nissan applications. This distributor does not include a coil wire, distributor cap, ignition rotor, or integrated ignition coil.

This part cross-references Nissan (e.g., 22100D3315) for the same application.

What It Helps Fix

• Hard starting caused by weak or inconsistent ignition timing
• Misfires related to distributor wear or module failure
• Rough idle from poor spark delivery
• Check engine light concerns tied to ignition timing errors
• Oil leakage or premature distributor failure from worn internal tolerances

Installation Notes

Before installation, verify the vehicle uses a magnetic coil distributor and confirm connector and harness polarity match the original unit. Transfer any components not included with this part, such as the cap, rotor, and coil wire, from the existing assembly if required by the application. After installation, set ignition timing according to factory service procedures and inspect related ignition components for wear.

Quality Assurance

Cardone remanufactures this distributor to stringent standards and tests electronic module components for full functionality. Automated verification checks critical operating points so the finished unit meets or exceeds original equipment performance expectations.