Cardone 31-17407 Distributor

Remanufactured Distributor for Honda and Acura

The Cardone 31-17407 remanufactured distributor is built for 4-cylinder ignition systems that use a magnetic coil design. It restores proper spark timing and voltage delivery to the spark plugs, helping the engine run with the correct firing pattern.

Compatible with 1994-1995 Honda Civic del Sol with TEC Distributor and 1992-1993 Acura Integra upgrade applications, this distributor is a direct-fit ignition service part for specific OE-style setups.

Key Features

• Remanufactured distributor for 4-cylinder applications
• Electronic module supplied
• Magnetic coil distributor type
• 100% new points and condensers installed where applicable
• All electronic module components are computer tested for function
• Automated test equipment checks signal strength, polarity, air gap, reluctor tooth size, coil performance, and pickup performance
• Meets or exceeds OEM performance targets
• Precise machining tolerances help prevent oil leakage, timing issues, check engine light concerns, and premature failure
• Guaranteed fit and function

Product Details

Cardone Distributor 31-17407 is a remanufactured ignition distributor from Cardone’s Distributor line, focused on restoring dependable spark control in vehicles that rely on a magnetic coil distributor. The unit is remanufactured under stringent quality standards, with worn OE components replaced or repaired where needed to meet or exceed OE performance. For drivers searching for a Honda Civic del Sol distributor or an Acura Integra distributor replacement, this part number provides a targeted solution for the listed applications.

This part cross-references Honda 30105P30006 and Acura 30100P30006 for the same application.

Common Issues It Can Help Resolve

• Hard starting caused by weak or inconsistent ignition timing
• Misfire concerns related to distributor wear or module failure
• Rough idle from poor spark delivery
• Check engine light issues tied to distributor signal or timing errors
• Oil leakage or premature distributor failure from worn internal tolerances

Installation Notes and Tips

• Verify vehicle application by year, make, model, and distributor ID before ordering.
• Confirm the existing setup uses a TEC Distributor or the specified electronic distributor configuration.
• Inspect ignition wires, cap, rotor, and related components during service; this distributor does not include a cap, rotor, or coil wire.
• Follow factory timing and diagnostic procedures after installation.
• Use clean mounting surfaces and check connector condition before final assembly.

Quality Assurance

Each Cardone remanufactured distributor is tested with automated equipment to verify electrical and mechanical performance, including signal strength and pickup operation. The product is remanufactured to meet stringent quality standards and is backed by Cardone’s guaranteed fit and function approach.