Cardone 31-59400 Distributor

Remanufactured Distributor for Nissan 4-Cylinder Engines

Cardone 31-59400 is a remanufactured Hall Effect distributor built for select Nissan 4-cylinder applications. It is engineered to deliver proper voltage to the spark plugs at the correct timing pattern, helping the engine run consistently under load and at idle.

Compatible with 1995-1999 Nissan Sentra and 1995-1998 Nissan 200SX, this distributor is a direct-fit ignition replacement for vehicles that use an electronically controlled distributor design.

Key Features

• Hall Effect distributor type for electronic ignition control
• Remanufactured under stringent quality standards
• 100% new points and condensers installed where applicable
• Electronic module components are computer tested for full functionality
• Automated test equipment checks signal strength, polarity, air gap, reluctor tooth size, coil performance, and pickup performance
• Precise machining tolerances help prevent oil leakage, timing issues, check engine light concerns, and premature failure
• Meets or exceeds O.E.M. performance requirements
• Guaranteed fit and function

Product Details

This Cardone Distributor line focuses on remanufactured ignition components that restore dependable spark timing without changing the original vehicle setup. Part number 31-59400 is built for 4-cylinder Nissan applications and is intended for vehicles that rely on an electronically controlled distributor for ignition timing accuracy. If you are searching for a remanufactured distributor for a 1995-1999 Nissan Sentra or a 1995-1998 Nissan 200SX, this unit matches the listed application.

This part cross-references Nissan OE numbers 22100OM220 and 22100OM301 for the same application.

Common Issues This Part May Address

• Hard starting caused by weak or inconsistent spark timing
• Misfire or rough running from distributor wear
• Timing instability from failing internal ignition components
• Oil leakage around the distributor housing
• Check engine light concerns related to distributor signal problems

Installation Notes

Before installation, verify the vehicle uses the correct Hall Effect distributor configuration and confirm all ignition connections are clean and secure. This distributor does not include a distributor cap, ignition rotor, coil wire, or integrated ignition coil, and the electronic module is not supplied. Follow factory timing procedures after installation to ensure proper engine operation.

Quality Assurance

Cardone remanufactured distributors are tested for signal integrity and ignition performance using automated equipment, with worn OE components replaced or repaired to meet or exceed original equipment standards. Part number 31-59400 is built to support reliable fitment and consistent ignition function on the listed Nissan applications.