Cardone 31-691 Distributor

Remanufactured Distributor for 1980 Honda

The Cardone 31-691 remanufactured distributor is built for 1980 Honda Accord and 1980 Honda Prelude applications with California Emission System electronic distributor setups. It is engineered to deliver proper voltage to the spark plugs at the correct timing pattern for consistent engine operation.

As part of the Cardone Distributor line, this remanufactured unit is restored to meet or exceed original equipment performance standards with verified fit and function for the listed applications.

Key Features

• Remanufactured distributor for 4-cylinder applications
• Magnetic coil distributor type
• 100% new points and condensers installed where applicable
• Electronic module components are computer tested for full functionality
• Automated test equipment checks signal strength, polarity, air gap, reluctor tooth size, ignition coil, and pickup performance
• Precise machining tolerances help prevent oil leakage, timing issues, check engine light concerns, and premature failure
• Meets or exceeds O.E.M. performance standards
• Guaranteed fit and function

Detailed Description

Cardone 31-691 is a remanufactured gray distributor for 1980 Honda Accord and 1980 Honda Prelude models equipped with the California Emission System electronic distributor configuration. This distributor is designed to restore ignition timing accuracy by transmitting voltage to the spark plugs in the correct sequence, helping the engine run as intended. The unit is remanufactured under stringent quality standards, with worn O.E. components replaced or repaired to address common failure points and support reliable ignition performance.

This part cross-references Honda 30100PB2691 and D4R903 for the same application.

What It Helps Resolve

• Hard starting caused by distributor wear
• Misfire from inconsistent spark timing
• Rough idle related to ignition signal loss
• Oil leakage from worn distributor machining surfaces
• Check engine light concerns tied to ignition timing faults

Installation Notes and Tips

Verify the vehicle uses the California Emission System electronic distributor configuration before installation. This unit does not include a distributor cap, ignition rotor, coil wire, integrated ignition coil, or electronic module. Confirm all related ignition components are in serviceable condition and transfer or replace only the parts required for your application.

For best results, align the distributor carefully during installation and verify ignition timing after the unit is installed on the vehicle.

Quality Assurance

Cardone remanufactures this distributor under controlled quality standards and tests electronic module components for functionality. Automated testing is used to verify critical operating characteristics, and the finished unit is checked for fit and performance against original equipment expectations.

• Fits 1980 Honda Accord, N/A
• Fits 1980 Honda Prelude, N/A