Cardone 31-856 Distributor

Remanufactured Distributor for Subaru Ignition Service

Cardone 31-856 is a remanufactured distributor built for reliable ignition performance and correct spark timing. It is a direct-fit replacement for Subaru applications that use a 3-cylinder magnetic coil distributor design, with electronic module components supplied for service-ready installation.

Cardone’s Distributor line focuses on remanufactured ignition components that are tested for fit, function, and signal quality. For Subaru distributor replacement needs, this part number 31-856 is built to restore consistent voltage delivery to the spark plugs and support proper engine operation.

Key Features

• Remanufactured distributor for ignition system repair
• Magnetic coil distributor type
• Electronic module supplied
• 100% new points and condensers installed where applicable
• Computer-tested electronic module components for full functionality
• Automated testing verifies signal strength, polarity, air gap, reluctor tooth size, ignition coil, and pickup performance
• Precise machining tolerances help prevent oil leakage, timing issues, check engine light concerns, and premature failure
• Meets or exceeds O.E.M. performance standards
• Guaranteed fit and function

Detailed Description

Cardone 31-856 is a gray remanufactured distributor for 3-cylinder Subaru ignition systems. It does not include a distributor cap, coil wire, ignition rotor, or integrated ignition coil, and it uses a magnetic coil distributor design with the electronic module supplied. This part is engineered to restore proper spark timing and stable voltage transmission to the plugs, helping the engine run as intended.

As part of the Cardone Distributor product line, this unit is remanufactured under stringent quality standards and verified with automated test equipment before release. It is a practical choice for Subaru distributor replacement when the original unit shows wear, timing instability, or electronic failure. Part number 31-856 is also referenced by Subaru 22100KA080 and 22100KA081 for the same application.

What It Helps Fix

• Hard starting caused by distributor wear or signal loss
• Rough idle from inconsistent ignition timing
• Misfire conditions related to weak spark delivery
• Check engine light concerns tied to distributor performance
• Oil leakage or premature failure from worn distributor machining surfaces

Installation Notes and Tips

Before installation, confirm the vehicle uses a 3-cylinder magnetic coil distributor setup and verify connector and harness orientation. Transfer any required external components not included with this unit, such as the distributor cap, rotor, and coil wire, if your application uses them. After installation, set ignition timing according to Subaru service specifications and inspect related ignition components for wear.

Quality Assurance

Cardone remanufactures this distributor under stringent quality controls and tests electronic module components for proper operation. Automated verification checks signal strength, polarity, air gap, reluctor tooth size, and pickup performance to support dependable ignition service on Subaru applications.