Cardone 31-S4400 Engine Crankshaft Position Sensor

Engine Crankshaft Position Sensor for Mitsubishi and Plymouth

The Cardone 31-S4400 is a remanufactured engine crankshaft position sensor built for direct-fit replacement on select Mitsubishi and Plymouth applications. It is tested for signal strength, harness polarity, ignition coil quality, and pick-up performance to help restore reliable engine timing input and consistent starting.

Key Features

• Remanufactured engine crankshaft position sensor
• 100% computer-tested electronic module components for full functionality
• Guaranteed fit and function
• Meets or exceeds OEM performance targets
• High-failure OE components are replaced or repaired to restore performance
• Precise machining tolerances help prevent oil leakage, timing issues, check engine light concerns, and premature failure
• Pin connector/terminal configuration
• Includes sensor and instruction sheet

Product Details

Cardone’s Engine Crankshaft Position Sensor line focuses on remanufactured electronic components that are verified before release. For this application, the 31-S4400 is engineered to deliver the signal accuracy needed by the ignition system and engine management system. This part cross-references Mitsubishi MD184529 for the same application.

Compatible With 1993-1994 Mitsubishi Eclipse, N/A; 1992 Mitsubishi Eclipse, N/A from 05/1992; 1992 Mitsubishi Galant, N/A; and 1993-1994 Plymouth Laser, N/A. If you are searching for a Mitsubishi Eclipse crankshaft position sensor or a Plymouth Laser engine crank angle sensor, this part number is the direct-fit remanufactured option.

What It Helps Address

• Hard starting or no-start conditions related to crankshaft position signal loss
• Erratic ignition timing or poor engine synchronization
• Check engine light concerns tied to sensor output faults
• Oil leakage or fitment issues caused by worn sensor tolerances
• Intermittent drivability problems from inconsistent pick-up performance

Installation Notes

Verify connector style and vehicle application before installation. The pin terminal configuration should match the original unit, and the sensor should be installed according to the included instruction sheet. Confirm the mounting area is clean and inspect related wiring and ignition components during replacement.

Quality Assurance

Each unit is remanufactured and tested to verify electronic function and signal performance before it leaves the factory. Cardone states that this product is built to meet or exceed OEM performance expectations for the listed applications.