Cardone 31-S7400 Engine Camshaft Position Sensor

Engine Camshaft Position Sensor for Tracker and Vitara

Cardone 31-S7400 is a remanufactured engine camshaft position sensor built for reliable signal output and consistent engine timing feedback. It is a direct-fit replacement for select Chevrolet Tracker and Suzuki Vitara applications, with testing focused on signal strength, harness polarity, ignition coil quality, and pick-up performance.

Key Features

• Remanufactured camshaft position sensor for ignition system service
• 100% computer-tested electronic module components for full functionality
• Guaranteed fit and function for the listed applications
• Meets or exceeds O.E.M. performance requirements
• High-failure O.E. components are replaced or repaired to restore performance
• Precise machining tolerances help prevent oil leakage, poor timing, check engine light issues, and premature failure
• Connector/terminal configuration: pin
• Package contents: sensor and instruction sheet

Product Details

The Cardone Engine Camshaft Position Sensor line focuses on remanufactured ignition sensors that are tested before release and restored with attention to the components that most often fail in service. For buyers searching for a Cardone 31-S7400 camshaft position sensor for a Chevrolet Tracker or Suzuki Vitara, this part is built to deliver stable camshaft position feedback so the engine control system can manage timing and starting behavior correctly. This part cross-references Suzuki 3310065D00 for the same application.

What It Helps Address

• Hard starting or no-start conditions related to camshaft signal loss
• Intermittent check engine light concerns tied to camshaft position input
• Poor timing control caused by an inaccurate sensor signal
• Oil leakage concerns from worn or poorly machined sensor interfaces
• Driveability issues from inconsistent ignition and pick-up performance

Installation Notes

Compatible With 1999-2004 Chevrolet Tracker and 1999-2002 Suzuki Vitara, engine camshaft position sensor applications. Verify connector style, mounting location, and OE part number before installation. Clean the mounting area, inspect the harness and terminals for damage, and follow the included instruction sheet during replacement. After installation, clear any stored diagnostic trouble codes and confirm proper engine start and sensor operation.

Quality Assurance

Cardone remanufactured sensors are tested for signal strength, wire harness polarity, ignition coil quality, and overall pick-up performance. The product is also backed by Cardone’s remanufactured component standards, with worn O.E. parts replaced or repaired to meet performance expectations for the listed vehicles.