Cardone 40-247 Wiper Motor - Rear

Cardone 40-247 Rear Wiper Motor

Restore rear wiper operation with the Cardone 40-247 windshield wiper motor, a remanufactured OE-style replacement built for direct fit and dependable performance. This unit is listed for 1986-1990 Ford Bronco II rear applications, including models without washer pump compatibility.

Key Features

• Remanufactured Original Equipment part for a precise vehicle fit
• Direct bolt mounting with 2 mounting holes
• Blade terminal type for factory-style connection
• Main components tested or gauged to OE standards, including armature, field, bearing, parking switch, or pulse board
• Motor bearings are re-impregnated or replaced as needed
• Output gear lubrication supports load capacity and service life
• Motor magnets are fully recharged for performance and reliability
• Weak solder points are reflowed to improve durability
• Package contents include the wiper motor and instruction sheet
• Washer pump not included

Product Details

The Cardone Windshield Wiper Motor line is built around remanufactured OE components that are re-engineered, tested, and verified to match original performance. The 40-247 is a rear wiper motor for Ford Bronco II models, and it is a practical choice when the original rear wiper motor has failed, parks incorrectly, or no longer responds consistently. This part cross-references Ford E4TZ17508A and E7TZ17508B for the same application.

Compatible With 1986 Ford Bronco II, rear from 06/1986, motor without washer pump; and 1987-1990 Ford Bronco II, rear, excluding washer pump compatibility. Search terms such as Ford Bronco II rear wiper motor, remanufactured windshield wiper motor, and Cardone 40-247 fit these applications.

Common Problems This Part Can Help Address

• Rear wiper motor no longer runs
• Wipers stop in the middle of the windshield or fail to park correctly
• Intermittent rear wiper movement
• Weak or slow wiper operation
• Noise or binding from a worn motor assembly

Installation Notes and Tips

Verify the vehicle uses the rear motor configuration listed for the Ford Bronco II before installation. If the wipers do not park correctly after replacement, check crank arm position on the motor shaft and follow the vehicle-specific hidden park reset procedure when applicable. For moisture-sensitive systems, confirm the rain sensor and washer pump condition before replacing the motor, since some systems will not operate properly if the washer pump is defective.

Quality Assurance

Cardone remanufactures this motor to OE standards and tests the finished unit for function before release. The remanufacturing process also reduces energy and raw material use compared with producing a new part, supporting lower waste in automotive repair.