Cardone 40-3044 Windshield Wiper Motor - Front

Cardone 40-3044 Wiper Motor for Sprinter

Restore dependable windshield wiping with the Cardone 40-3044 remanufactured windshield wiper motor. Built for direct-bolt installation and OE-style fit, this front wiper motor is made for 2003-2006 Dodge Sprinter 2500 and 2003-2006 Dodge Sprinter 3500 applications.

Key Features

• Remanufactured Original Equipment part for a precise vehicle fit
• Direct bolt mounting with 3 mounting holes
• Pin terminal design for the original electrical connection
• Motor bearings re-impregnated or replaced as needed
• Output gear lubricated for load capacity and service life
• Motor magnets fully recharged for performance and reliability
• Weak solder points reflowed during remanufacturing
• Package contents: wiper motor and instruction sheet

Product Details

Cardone’s Windshield Wiper Motor line is built around remanufactured OE cores that are re-engineered, tested, and verified to match original performance. The 40-3044 is a front wiper motor for Dodge Sprinter 2500 and Dodge Sprinter 3500 models, and it cross-references Dodge and Freightliner OE numbers 5103561AA and 5103870AA for the same application. Each unit is evaluated against OE standards, then function-tested on the vehicle to confirm operation before it leaves the remanufacturing process.

This part is also produced with an earth-friendly remanufacturing process that reduces the energy and raw material needed versus manufacturing a new part. For Sprinter owners searching for a remanufactured windshield wiper motor for 2003-2006 Dodge Sprinter 2500 or 3500 front applications, Cardone 40-3044 provides an OE-style replacement built for long-term use.

Common Problems This Part Can Address

• Wipers that stop in the middle of the windshield
• Intermittent or slow wiper motor operation
• Loss of parking position after motor replacement
• Wiper motor noise caused by worn internal components
• Electrical failure related to worn solder joints or weak magnets

Installation Notes and Tips

Verify the vehicle uses the correct front wiper motor application before installation. If the vehicle has a moisture-sensitive wiper system, confirm the rain sensor and control module are functioning properly, since system inputs can affect motor operation. If the wipers do not park correctly and the vehicle does not use hidden wiper blades, check crank arm position on the motor shaft and reset it to the proper park angle using the vehicle service procedure.

If the motor does not operate after installation and the washer pump was transferred from the old assembly, bench test both the wiper motor and washer pump. Some systems will not run the motor if the washer pump has failed. This part does not include a washer pump.

Quality Assurance

Cardone remanufactured wiper motors are re-engineered to match OE performance, with main components tested or gauged to OE standards and final function checks completed on the vehicle. The remanufacturing process is designed to deliver consistent operation while reducing material and energy use compared with new-part production.