Cardone 40-431 Windshield Wiper Motor - Front

Remanufactured Wiper Motor for Jeep Front Applications

The Cardone 40-431 windshield wiper motor is a remanufactured OE-style replacement built for direct fitment and dependable front wiper operation. It is engineered and tested to match original equipment performance for 1984-1990 Jeep Cherokee, 1986-1990 Jeep Comanche, and 1984-1990 Jeep Wagoneer front applications.

Cardone’s Windshield Wiper Motor line focuses on remanufactured OE replacement parts for drivers who need correct fit, consistent operation, and long-term reliability. The 40-431 follows that approach with reconditioned internal components and final functional testing before release.

Key Features

• Remanufactured Original Equipment part for a direct vehicle fit
• Each unit is tested or gauged against OE standards before final assembly
• Armature, field, bearing, parking switch, and pulse board components are evaluated as applicable
• Motor bearings are re-impregnated or replaced as needed
• Output gear lubrication is applied for load capacity and service life
• Motor magnets are fully recharged for performance and reliability
• Weak solder points are reflowed to improve durability
• Earth-friendly remanufacturing reduces energy and raw material use versus new part production
• Package contents: wiper motor and instruction sheet
• Terminal type: pin; mounting type: direct bolt; mounting hole quantity: 3

Detailed Description

Cardone 40-431 is a remanufactured windshield wiper motor designed for front wiper systems on Jeep Cherokee, Jeep Comanche, and Jeep Wagoneer models listed in the fitment data. It is built to restore proper windshield wiping performance with OE-style dimensions and function, making it a practical choice for Jeep owners searching for a remanufactured wiper motor for 1984-1990 Jeep Cherokee front, 1986-1990 Jeep Comanche front, or 1984-1990 Jeep Wagoneer front service.

This part cross-references Jeep 56000899 and 56001402 for the same application.

Common Problems This Part Can Address

• Intermittent or inoperative front windshield wiper movement
• Wipers stopping in the middle of the windshield
• Poor park position after motor replacement or service
• Reduced motor output from worn internal components
• Noise or inconsistent operation caused by bearing or gear wear

Installation Notes and Tips

Confirm the vehicle uses the listed front application before ordering. This unit does not include a washer pump, and Cardone notes that some wiper systems will not operate if the washer pump is defective, so bench test the wiper motor and washer pump before replacing either. If the motor does not have hidden wiper blades, parking misalignment is often caused by crank arm position; adjust the crank arm angle on the motor shaft to restore proper park location. Refer to a vehicle-specific service manual for the hidden-park reset procedure when applicable.

For moisture-sensitive systems, a rain sensor mounted inside the windshield near the rearview mirror sends input to the control module, which then adjusts wiper motor speed. If diagnosing that type of system, verify the sensor and control module operation as part of the repair process.

Quality Assurance

Cardone remanufactured wiper motors are re-engineered, built, and tested to match OE performance. The remanufacturing process reuses serviceable core materials, replaces or restores worn internal parts, and supports reduced material waste compared with manufacturing a new component.