Cardone 42-3080 Power Window Motor - Front Right

Cardone Power Window Motor 42-3080

Restore front-right window operation with this remanufactured CARDONE power window motor. Built as a direct-fit O.E. replacement, Part Number 42-3080 is engineered from original equipment cores and tested for speed, strength, and fit on the vehicle application.

Compatible with Ford Expedition and Lincoln Navigator front right applications, this remanufactured window motor is a practical replacement for a failed or slow-moving power window system. The CARDONE Power Window Motor line focuses on OE-style fitment and renewed internal components for dependable operation.

Key Features

• Remanufactured Original Equipment replacement for direct vehicle fit
• 100% tested on a simulated window fixture for speed and strength
• Internal components inspected, gauged, and renewed for reuse or replacement as needed
• Lubricated for quiet operation and long service life
• Fully compatible with OE mounting and regulator design
• Motor magnets are recharged to support efficient operation
• Gear included; regulator not included
• Front right window motor use location

Detailed Description

CARDONE remanufactured window lift motors are rebuilt from original equipment cores and re-engineered to match OE performance. For this application, Part Number 42-3080 is a front right window motor for 2007-2011 Ford Expedition and 2011 Lincoln Navigator, with additional coverage for 2007-2010 Lincoln Navigator and 2008-2009 Ford Expedition. The unit includes an 8-wire design, 6 mounting holes, through-hole mounting, and a gear included configuration.

This part cross-references Ford AL7Z7823394A and Lincoln 7L7Z7823394A for the same application. Use 42-3080 when replacing a worn or inoperative power window motor on the front passenger side of the Ford Expedition or Lincoln Navigator.

Common Problems This Part Can Address

• Window glass that will not move up or down
• Slow, weak, or intermittent window movement
• Motor noise without normal window travel
• Window operation that stops before reaching full travel
• Failure of the front right power window motor

Installation Notes and Tips

Install the motor with the regulator fully coupled before operating it. Express-up and anti-pinch systems can require travel-limit reset if the motor is bench-tested or moved out of its factory-set position before installation. If the vehicle uses an anti-pinch feature, follow the service manual procedure to initialize the system after installation.

For 2-wire systems, verify polarity and switch operation if the motor runs in only one direction. If the vehicle uses a case-grounded design, apply ground to the housing as required by the original circuit layout. Inspect the regulator, tracks, weather-strip, and switch contacts during diagnosis to avoid replacing a good motor unnecessarily.

Quality Assurance

Each CARDONE remanufactured window lift motor is inspected, tested, and renewed to support OE-level performance. Internal gears are gauged and renewed or replaced when out of specification, bearings are replaced as needed, and lubricant is applied in the correct amount for quiet operation. The remanufacturing process also reduces raw material and energy use compared with producing a new part.