Cardone 42-3092 Power Window Motor - Rear Left

Cardone Rear Left Window Motor for Explorer

Restore smooth rear window operation with this remanufactured Cardone power window motor, part number 42-3092. Built as a direct-fit O.E. replacement, it is engineered from original equipment cores and tested to deliver the speed, strength, and fit expected for the rear left window on select Ford and Mercury applications.

Compatible with 2006-2010 Ford Explorer, rear left; 2007-2010 Ford Explorer Sport Trac, rear left; and 2006-2010 Mercury Mountaineer, rear left.

• Remanufactured Original Equipment-style window lift motor for direct fitment
• 100% tested on a simulated window fixture for speed and strength verification
• Internal components inspected, gauged, and renewed for reliable operation
• Lubricated for quiet movement and long service life
• 2-wire design with gear included and 3 mounting holes
• Fully compatible with the original mounting and regulator interface
• Part number 42-3092 for rear left window applications

Product Details

Cardone’s Power Window Motor line focuses on remanufactured OE replacements that begin with original equipment cores, then are re-engineered, renewed, and tested to match factory performance. For vehicles such as the Ford Explorer, Explorer Sport Trac, and Mercury Mountaineer, this approach helps maintain proper window travel and dependable operation without changing the original mounting design. The motor is shipped with the gear included and is intended for rear left use only. This part cross-references Ford and Mercury OE number 6L2Z7823394CA for the same application.

Common Problems This Part Can Address

• Rear window moves slowly or stops before reaching full travel
• Window does not respond when the switch is activated
• Motor runs but the glass does not move properly
• Intermittent rear left window operation on Ford Explorer or Mercury Mountaineer
• Noisy or uneven window movement caused by worn motor internals

Installation Notes and Tips

Use the vehicle-specific service procedure for installation. This 2-wire motor depends on correct polarity for direction control, so wiring and switch condition should be verified if the window only operates one way. Do not bench-test an express-up or anti-pinch motor before it is fully coupled to the regulator, as travel limits can be affected. If the motor is installed and left in its factory-set position, reset is typically not required.

Quality Assurance

Each Cardone remanufactured window lift motor is inspected, gauged, recharged, and tested before release. Internal gears are renewed or replaced as needed, magnets are recharged, and lubrication is applied to support quiet, consistent operation. The remanufacturing process also reduces raw material and energy use compared with producing a new part.