Cardone 43-1427 Windshield Wiper Motor - Front

Cardone Remanufactured Wiper Motor for Front Applications

Restore dependable windshield wiping performance with the Cardone 43-1427 remanufactured windshield wiper motor. Built for direct-fit replacement on select Acura CL, Acura TL, and Honda Accord front applications, this unit is re-engineered and tested to match original equipment performance.

Cardone’s Windshield Wiper Motor line focuses on remanufactured OE-style replacement parts for drivers who need consistent operation, proper fitment, and long-term reliability. The 43-1427 is part of that product line and is built for vehicles that use a direct-bolt, blade-terminal motor design.

Key Features

• Remanufactured Original Equipment part for a precise vehicle fit
• Each unit is tested against OE standards, including core components such as the armature, field, bearing, parking switch, or pulse board
• Final function testing is performed on the vehicle
• Motor bearings are re-impregnated or replaced as needed
• Output gear lubrication is applied for load capacity and service life
• Motor magnets are fully recharged for performance and reliability
• Weak solder points are reflowed to improve durability
• Earth-friendly remanufacturing process reduces energy and raw material use versus producing a new part

Detailed Description

The Cardone 43-1427 windshield wiper motor is a remanufactured replacement built to restore front wiper operation on 1997-1999 Acura CL, 1995-1998 Acura TL, and 1994-1997 Honda Accord models. It uses a direct bolt mounting style with three mounting holes and blade terminals, and it is supplied as a wiper motor with instruction sheet. Washer pump included: no.

This part cross-references Acura 76505SV4A01 and 76505SW5A01 for the same application. If you are searching for a 1994-1997 Honda Accord front wiper motor, a 1995-1998 Acura TL front windshield wiper motor, or a 1997-1999 Acura CL front wiper motor, the Cardone 43-1427 is the OE-style remanufactured replacement to review.

What It Helps Fix

• Intermittent or inoperative front windshield wiper movement
• Wipers stopping in the middle of the windshield
• Poor parking position after motor replacement
• Noise or drag caused by worn internal motor components
• Loss of wiper performance from weakened bearings, magnets, or solder joints

Installation Notes and Tips

Confirm vehicle fitment before installation, especially because this part excludes washer pump compatibility. If the wiper motor does not operate after installation, inspect the washer pump and related circuit before replacing the motor again. For vehicles without hidden wiper blades, parking misalignment is often corrected by adjusting the crank arm position on the motor shaft so the blades park at the bottom of the windshield. Refer to a vehicle-specific service manual for the hidden-park reset procedure when applicable.

For moisture-sensitive systems, a rain sensor mounted inside the windshield near the rearview mirror may control wiper speed through the module. If your vehicle uses this setup, verify the sensor and control module operation during diagnosis. The Cardone 43-1427 is a direct-fit replacement for select Acura CL, Acura TL, and Honda Accord front wiper motor applications, but the washer pump must be evaluated separately.

Quality Assurance

Cardone remanufactures this wiper motor to OE standards, with component-level testing and final vehicle-function verification. The process is designed to deliver consistent performance while reducing material and energy use compared with manufacturing a new part.