Cardone 43-2060 Windshield Wiper Motor - Rear

Cardone Rear Wiper Motor for Toyota Sienna

Restore rear wiper operation with this remanufactured Cardone windshield wiper motor, part number 43-2060. It is built to match original equipment performance and is engineered for a direct vehicle fit on the rear of select Toyota Sienna models.

Fits 2004-2010 Toyota Sienna, rear. This Cardone 43-2060 remanufactured wiper motor is a practical OE-style replacement for rear wiper service on the Toyota Sienna.

Key Features

• Remanufactured Original Equipment part for correct fit and function
• Main components are tested or gauged to O.E. standards before final assembly
• Final unit is function-tested on the vehicle
• Motor bearings are re-impregnated or replaced as needed
• Output gear receives lubrication for load capacity and service life
• Motor magnets are fully recharged for reliable operation
• Weak solder points are reflowed to improve durability
• Earth-friendly remanufacturing process reduces energy and raw material use versus making a new part

Product Details

Cardone’s Windshield Wiper Motor line focuses on remanufactured OE replacement components built for dependable operation. Part number 43-2060 is designed for rear wiper service on the Toyota Sienna and is supplied with an instruction sheet. The unit uses a blade terminal type, grommet mounting, and three mounting holes, with no washer pump included. For shoppers searching for a rear wiper motor for 2004-2010 Toyota Sienna or a remanufactured Toyota Sienna rear windshield wiper motor, this part matches the listed application.

This part cross-references Toyota 85130AE010 for the same application.

Common Problems This Part Can Address

• Rear wiper motor no longer moves the wiper arm
• Intermittent or slow rear wiper operation
• Wiper motor stops in the middle of the windshield or rear glass
• Parking position is out of alignment after replacement or service
• Electrical wear inside the motor assembly affecting consistent operation

Installation Notes

Confirm vehicle fitment before installation on 2004-2010 Toyota Sienna rear applications. If the vehicle uses a hidden park setup, follow the service manual reset procedure and adjust the crank arm position as needed so the wipers park at the bottom of the glass. If the motor does not operate after installation, check washer pump function as some systems will not run with a defective pump. Bench test the wiper motor and washer pump before replacing either component.

Quality Assurance

Each Cardone remanufactured wiper motor is re-engineered, built, and tested to match original equipment performance. The remanufacturing process includes component inspection, bearing service, magnet recharging, solder reflow, lubrication, and final functional testing to support reliable operation on the vehicle.