Cardone 43-2110 Windshield Wiper Motor - Rear

Cardone Rear Wiper Motor for BMW X3

Restore rear wiper operation with this remanufactured Cardone windshield wiper motor, part number 43-2110. It is built to match original equipment performance for the 2004-2010 BMW X3 rear application and is a direct-fit replacement for vehicles with the listed configuration.

Key Features

• Remanufactured Original Equipment-style replacement for a precise vehicle fit
• Fits 2004-2010 BMW X3, rear
• Main components are tested or gauged to O.E. standards before final function testing
• Motor bearings are re-impregnated or replaced as needed
• Output gear lubrication is applied for load capacity and service life
• Motor magnets are fully recharged for consistent performance
• Weak solder points are reflowed to improve durability
• Package contents: wiper motor and instruction sheet
• Mounting type: grommet; mounting hole quantity: 3
• Terminal type: bullet and pin
• Washer pump not included

Product Details

Cardone’s remanufactured wiper motor line is built around OE fit and function, with each unit re-engineered, assembled, and tested to meet original performance expectations. Part number 43-2110 is a rear windshield wiper motor for BMW X3 models from 2004 through 2010, and it is listed with washer pump compatibility exclusions. This part cross-references BMW 67636917907 for the same application.

Common Problems This Part Can Address

• Rear wiper motor failure or no movement
• Intermittent rear wiper operation
• Wiper parking issues at the rear glass
• Slow or weak rear wiper sweep
• Electrical wear related to internal motor components

Installation Notes and Tips

Confirm the vehicle is a 2004-2010 BMW X3 with rear wiper motor application before ordering. If the wiper system does not operate after installation, inspect the washer pump and related circuit components, since some systems will not run if the washer pump is defective. If the wipers stop in the middle of the glass, check crank arm position and reset the park alignment according to the vehicle service procedure. For moisture-sensitive systems, verify the presence of the rain sensor and control module before diagnosis.

Quality Assurance

Each Cardone remanufactured wiper motor is tested against OE standards, including component-level inspection and final vehicle-function testing. The remanufacturing process also reduces raw material and energy use compared with producing a new part, supporting lower waste through reuse of serviceable core components.