Cardone 43-3533 Windshield Wiper Motor - Rear

Rear Wiper Motor for Audi Applications

Restore rear wiper operation with this remanufactured Cardone windshield wiper motor, part number 43-3533. It is built to match original equipment performance for Audi rear wiper systems, including Audi Q5, SQ5, Q7, A3, A3 Quattro, A4 Quattro, S4, and A4 applications.

Cardone’s Windshield Wiper Motor line focuses on OE-style fit and function, with remanufactured components tested to original standards for dependable rear windshield wiping performance.

Key Features

• Remanufactured Original Equipment part for direct vehicle fit
• Main components tested or gauged to OE standards, then final-tested on the vehicle
• Motor bearings re-impregnated or replaced as needed
• Output gear lubricated for load capacity and service life
• Motor magnets recharged for consistent performance
• Weak solder points reflowed to improve durability
• Earth-friendly remanufacturing process reduces raw material and energy use by 80%
• Package includes the wiper motor and instruction sheet

Product Details

Cardone 43-3533 is a remanufactured rear windshield wiper motor engineered for Audi rear wiper systems. It is designed for vehicles that use a blade-terminal, grommet-mounted motor with three mounting holes and no washer pump included. This part cross-references Audi 8E9955711E and 8R0955711C for the same application.

Compatible With 2017 Audi Q5, rear; 2014-2017 Audi SQ5, rear; 2009-2016 Audi Q5, rear; 2007-2015 Audi Q7, rear; 2006-2013 Audi A3, rear; 2006-2013 Audi A3 Quattro, rear; 2002-2008 Audi A4 Quattro, rear; 2004-2008 Audi S4, rear; 2004-2005 Audi A4, rear.

Common Problems This Part Can Address

• Rear wiper motor failure or no rear wiper movement
• Intermittent rear wiper operation
• Wiper parking issues at the bottom of the rear glass
• Slow or weak rear wiper sweep
• Noise or binding from worn internal motor components

Installation Notes and Tips

Verify the vehicle uses a rear wiper motor with grommet mounting, blade terminals, and no washer pump compatibility before ordering. If the wipers do not park correctly after installation, check crank arm position and reset the park alignment using the vehicle-specific service procedure. If the motor does not operate after replacing the washer pump, bench test both components; some systems will not run if the washer pump is defective.

For moisture-sensitive systems, a rain sensor mounted inside the windshield near the rearview mirror may control wiper speed through the module. Confirm the vehicle’s rear wiper configuration before installation on Audi Q5, SQ5, or Q7 models.

Quality Assurance

Each Cardone remanufactured wiper motor is re-engineered, tested, and built to match OE performance. The remanufacturing process includes component inspection, bearing service, magnet recharging, lubrication, and electrical rework to support reliable operation in Audi rear wiper applications.