Cardone 47-10008 Power Window Motor - Front Right, Rear Left or Rear Right

Cardone Power Window Motor 47-10008

Restore window movement with this Cardone remanufactured power window motor, part number 47-10008. It is a direct-fit O.E. replacement built from original equipment cores and tested for speed, strength, and quiet operation.

Key Features

• Remanufactured Original Equipment window lift motor for a precise vehicle fit
• 100% tested on a simulated window fixture to verify motor speed and load strength
• Internal components inspected and gauged, with bushings re-impregnated and bearings replaced as needed
• Lubricant applied to support quiet operation and long service life
• Fully compatible with the O.E. mounting points and regulator
• Internal gears renewed or replaced with stronger material when required
• Motor magnets fully recharged for consistent efficiency and reliability
• Earth-friendly remanufacturing process reduces raw material and energy use versus making a new part

Product Details

Cardone Power Window Motor 47-10008 is built for drivers who need a direct replacement for a worn or failed window motor. This remanufactured unit is engineered from original equipment cores, then renewed and tested to match O.E. performance. It is listed for the front right, rear right, and rear left window motor locations, and it includes the gear with the motor. This part cross-references Toyota 8571033130 and Scion 8571042070 for the same application.

Fits 2001-2007 Toyota Highlander, front right. Fits 2001-2007 Toyota Highlander, rear right. Fits 2004-2006 Scion xA, front right. Fits 2002-2006 Toyota Camry, front right, Japan built. Fits 2002-2006 Toyota Camry, rear left, Japan built. Fits 2001-2005 Toyota RAV4, front right. Fits 2001-2005 Toyota RAV4, rear left.

What It Helps Fix

• Window glass that moves slowly or stops partway
• Motor noise, weak operation, or intermittent response
• Failure to raise or lower the window from the switch
• Wear-related issues from damaged internal gears or bearings
• Problems caused by an original motor that no longer matches O.E. performance

Installation Notes

Verify the vehicle application, position, and connector configuration before installation. This motor uses a 2-wire design, a threaded-hole mounting type, and a 3-hole mounting pattern. The regulator is not included, so reuse or replace the existing regulator as needed. For vehicles with auto up/down operation, output signals and pulse counts are matched to the application, and the motor ships in the full-up position.

Quality Assurance

Each unit is remanufactured, inspected, and fully tested before release. Cardone’s process includes component gauging, gear renewal, magnet recharging, and simulated-load testing to confirm operation. The remanufacturing process also reduces energy and raw material use compared with producing a new part.