Cardone 48-214 Transfer Case Motor

Remanufactured Transfer Case Motor

Cardone 48-214 is a remanufactured transfer case motor built for direct replacement service on select 1999 Ford trucks. It is engineered to restore transfer case shifting performance with computer-tested reliability and OE-style fitment for the Ford F-150 and Ford F-250.

Key Features

• Remanufactured transfer case motor for 4WD shift control
• Steel component housing for durable service
• Pin connector/terminal configuration
• Motor magnets are fully recharged for consistent operation
• Transfer case motor sensors are replaced with new, OE-quality sensors
• Lubricant is applied in the correct amount for quiet operation and long service life
• 100% computer tested at three points during remanufacturing

Product Line Details

Cardone Transfer Case Motor remanufactured units are built to address common failure points found in original equipment designs. The remanufacturing process focuses on restoring shifting performance, correcting design weaknesses identified through teardown analysis, and verifying operation before the part leaves the factory.

Detailed Description

This Cardone 48-214 transfer case motor is a direct-replacement solution for 1999 Ford F-150 models with a rectangular plug, 7-pin connector, and sensor ID #1A, as well as 1999 Ford F-250 applications listed for transfer case motor service. It is designed for drivers dealing with 4WD engagement problems, weak shift motor operation, or transfer case control issues that prevent proper drivetrain selection. This part cross-references Ford F65Z7G360AA for the same application.

What It Helps Solve

• Service 4WD light illumination
• Transfer case that will not shift into 4WD high or low
• Weak or inconsistent transfer case motor movement
• Error codes related to transfer case motor operation
• Loss of reliable drivetrain engagement on 1999 Ford F-150 and Ford F-250 trucks

Installation Notes and Tips

Before installation, manually shift the transfer case into the two-wheel drive position at the shift shaft. The replacement motor drive is factory-set in the 2WD position, and it should not be operated while removed from the transfer case because that can damage the motor and trigger an error code. A crescent wrench can be used for this operation. If the replacement motor drive is in a different position, reposition it before installing. Fits 1999 Ford F-150, N/A, with Rectangular Plug; with 7 Pin Connector; ID #(s) w/Sensor I.D. # 1A; Transfer Case Motor. Fits 1999 Ford F-250, N/A, Transfer Case Motor.

Quality Assurance

Each unit is computer tested at three stages during remanufacturing to verify operation. Cardone also replaces the transfer case motor sensors with new, OE-quality components and recharges the motor magnets to support reliable performance.