Cardone 48-256 Transfer Case Motor

Transfer Case Motor for Ford 4WD Systems

This Cardone remanufactured transfer case motor is a direct-replacement solution for Ford 4WD systems that need precise transfer case shifting. Built for 2012-2017 Ford Expedition and 2012-2014 Ford F-150 applications, part number 48-256 is remanufactured to meet or exceed original equipment performance.

Key Features

• Remanufactured transfer case motor for Ford Expedition and Ford F-150 4WD applications
• 100% computer tested at three points during the remanufacturing process
• Motor magnets are fully recharged for consistent operation
• Transfer case motor sensors are replaced with new, O.E.-quality sensors
• Assembled with the correct lubricant amount for quiet operation and long service life
• Metal housing with bullet connector/terminal configuration
• Package contents: transfer case motor and instruction sheet

Product Details

Cardone Transfer Case Motor 48-256 is engineered from reverse-engineered failure analysis to address original design weaknesses found in the factory unit. The remanufacturing process focuses on restoring reliable transfer case engagement and accurate position feedback, which is critical for 4WD operation in the Ford Expedition and Ford F-150. This direct replacement is built for vehicles that rely on a functioning transfer case motor to shift between drivetrain modes.

This part cross-references Ford CL3Z7G360A for the same application.

Common Problems This Part Can Address

• Service 4WD light illuminated
• 4WD inoperative in high or low range
• Transfer case motor failure to shift or complete engagement
• Weak or inconsistent motor movement during shift commands
• Incorrect transfer case position feedback from worn sensors

Installation Notes

Before installation, manually shift the transfer case into the same position as the replacement motor drive, which is factory-set in the 2-wheel drive position. Do not operate the motor while it is off the transfer case, as this can damage the unit and set an error code that must be cleared before operation resumes. If the drive position has been moved, return it to 2WD before installing. If the motor attempts to shift but sounds weak, inspect the front axle lock actuator and verify calibration and diagnostic trouble codes.

Fits 2012-2017 Ford Expedition, N/A. Fits 2012-2014 Ford F-150, N/A.

Quality Assurance

Each Cardone remanufactured transfer case motor is computer tested at three stages during the remanufacturing process to verify performance. The unit is rebuilt with new, O.E.-quality sensors, recharged magnets, and controlled lubrication to support reliable operation in Ford 4WD transfer case systems.