Cardone 53-2581 Power Brake Booster

Vacuum Power Brake Booster for Toyota Tacoma

The Cardone 53-2581 vacuum power brake booster is a remanufactured replacement built to match original equipment performance for select Toyota Tacoma applications. It is engineered for direct fitment on Tacoma models that use a vacuum brake booster and do not include a master cylinder.

Key Features

• Remanufactured to match O.E. performance
• Dual diaphragm design for consistent brake assist
• Steel construction with gray finish
• 100% tested for fit and function
• O.E. quality seals and check valves installed for reliable operation
• Rust-prohibitive finishing process helps extend service life
• Master cylinder output rods are pre-adjusted when included
• Guaranteed fit and function

Product Details

This Cardone Vacuum Power Brake Booster line focuses on restoring factory-style brake assist with remanufactured components that are re-engineered and tested before release. Part number 53-2581 uses a dual diaphragm setup with an 8.285-inch diaphragm diameter and an M8 x 1.25 master cylinder stud thread size. It is supplied as a booster only, with an instruction manual included, and is finished in gray steel for a clean, corrosion-resistant appearance.

Fits 2001 Toyota Tacoma, N/A; before 09/2000; without Master Cylinder; Vacuum Power Brake Booster. Fits 2000 Toyota Tacoma, N/A; with 8-3/4" Diameter Booster; without Master Cylinder; Vacuum Power Brake Booster. Fits 1995-1999 Toyota Tacoma, N/A; fits vehicles lacking master cylinders; Vacuum Power Brake Booster. This part cross-references Toyota 4461004040 for the same application.

Common Issues This Part Can Address

• Hard brake pedal feel caused by a failing booster
• Reduced brake assist during normal stopping
• Vacuum-related brake performance loss
• Brake system fitment issues when replacing a worn booster on a Toyota Tacoma
• Corrosion or seal wear in an original booster assembly

Installation Notes

Verify the vehicle’s brake booster style, diaphragm diameter, and master cylinder configuration before installation. This unit is intended for Tacoma applications without a master cylinder, and the 2001 fitment applies before 09/2000. Confirm the master cylinder stud thread size is M8 x 1.25 and compare the original booster to the replacement before bolting it in place.

Quality Assurance

Cardone remanufactures this brake booster to O.E. standards and tests every unit for proper fit and function. The original design is reviewed for improvement opportunities, and design upgrades are used where applicable to improve durability over the original part.