Cardone 53-4927 Power Brake Booster

Cardone Vacuum Power Brake Booster 53-4927

Restore brake assist with the Cardone 53-4927 vacuum power brake booster, a remanufactured replacement built to match original equipment performance. This unit is engineered for direct fitment on select Honda Odyssey models and is tested for fit and function before it leaves the factory.

Key Features

• Remanufactured to match O.E. performance
• Single-diaphragm design with a 10.965 in. diaphragm diameter
• Steel housing with gray finish and rust-prohibitive treatment
• 100% tested for reliable performance and proper function
• O.E.-quality seals and check valves installed for consistent brake assist
• Master cylinder output rods are pre-adjusted when included for easier installation
• Guaranteed fit and function

Product Details

The Cardone Vacuum Power Brake Booster brand line focuses on remanufactured brake boosters that are re-engineered and tested to meet original equipment standards. Part number 53-4927 is built for vehicles that use a vacuum-assisted brake booster and is listed for 2005-2010 Honda Odyssey models that lack master cylinders. It includes the booster, instruction manual, and M/C neck seal, with an M8 x 1.25 master cylinder stud thread size and a single diaphragm configuration.

This part cross-references Honda 01469SHJA00 for the same application. If you are searching for a remanufactured brake booster for a 2005-2010 Honda Odyssey, 53-4927 is the direct-fit option to compare against the original unit.

Common Problems This Part Can Address

• Hard brake pedal feel from a weak or failed booster
• Reduced brake assist during normal stopping
• Vacuum-related brake booster performance loss
• Fitment issues when replacing an original Honda Odyssey booster
• Corrosion or wear on an aging booster housing

Installation Notes

Fits 2005-2010 Honda Odyssey, N/A. Verify the vehicle uses the correct vacuum power brake booster configuration and confirm master cylinder interface details before installation. The pre-adjusted output rod feature, when included, helps reduce setup time, but final alignment and system checks should still be performed during installation.

Quality Assurance

Cardone remanufactures this booster to original equipment standards and tests every unit for fit and function. The rust-prohibitive finish, O.E.-quality seals, and check valves are used to support long-term reliability in normal brake system service.