Cardone 54-74210 Power Brake Booster

Vacuum Power Brake Booster for Ford Trucks

Restore brake assist with this remanufactured Cardone Vacuum Power Brake Booster, part number 54-74210. Built for direct replacement use on select Ford Bronco and Ford F-150 applications, it is re-engineered and tested to match original equipment performance.

The Cardone Vacuum Power Brake Booster line focuses on remanufactured brake boosters that are inspected for design improvements where applicable, then tested for fit and function before release.

Key Features

• Remanufactured steel power brake booster with a single diaphragm design
• 11.522 in. diaphragm diameter for listed Ford applications
• 100% tested for reliable performance and proper function
• O.E.-quality seals and check valves installed for consistent operation
• Rust-prohibitive finish helps extend service life
• Master cylinder output rods are pre-adjusted when included for easier installation
• Guaranteed fit and function for confirmed applications

Detailed Description

Cardone 54-74210 is a remanufactured vacuum power brake booster engineered for O.E.-style performance in select 1988-1993 Ford truck and SUV applications. It is built with a gray steel housing, single diaphragm construction, and an 11-1/2 inch class diaphragm diameter to match the listed brake system requirements. This part cross-references Ford E9TZ2005B for the same application.

Compatible With 1989-1993 Ford Bronco, N/A; 1989-1993 Ford F-150, N/A; 1989-1992 Ford F-250, N/A under 7000 lb GVW; 1989-1990 Ford F-200, N/A; 1988 Ford F-150, N/A with 11-1/2" diameter booster; and 1988 Ford F-200, N/A with 11-1/2" diameter booster. Use part number 54-74210 when replacing a worn booster on these Ford Bronco and Ford F-150 applications.

Common Problems It Can Address

• Hard brake pedal feel from a weak or failed booster
• Reduced brake assist during normal stopping
• Vacuum-related brake booster performance loss
• Brake pedal effort that has increased over time
• Replacement needs after booster leakage or internal wear

Installation Notes and Tips

Verify the vehicle’s brake system configuration before ordering, including master cylinder presence and diaphragm diameter where noted. This booster is listed for vehicles lacking master cylinders on several applications, and some fitments require the under-7000 lb GVW or 11-1/2 inch diameter specification. Follow the included instruction manual and confirm pushrod and mounting alignment during installation.

Quality Assurance

Each Cardone remanufactured power brake booster is 100% tested to confirm fit and function. The unit is re-engineered to match original equipment performance, with O.E.-quality seals and check valves installed and a rust-resistant finish applied for added durability.