Cardone 60-3220 CV Axle Assembly - Front Left

Cardone CV Axle Assembly for Jeep Front Left

Cardone 60-3220 is a remanufactured CV axle assembly for select Jeep applications, including the front left position on 1993-1998 Jeep Grand Cherokee and 1993 Jeep Grand Wagoneer with CV joint design axles. It is built for direct OE-style fitment and steady driveline performance.

Engineered from Cardone’s CV axle remanufacturing experience, this assembly focuses on seal integrity, grease retention, and straight shaft verification to help reduce vibration and extend service life. The Cardone 60-3220 is a practical replacement for Jeep Grand Cherokee front left CV axle service where OE fit and consistent operation matter.

Key Features

• Remanufactured Original Equipment part for direct vehicle fit
• Fits 1993-1998 Jeep Grand Cherokee, front left, with CV joint design axle
• Fits 1993 Jeep Grand Wagoneer, front left, with CV joint design axle
• ABS ring included with 54 teeth
• Compressed length: 22.625 in.
• Spline input and output shaft connection styles
• Boot clamps are pneumatically crimped for a tight seal
• Shafts are inspected for runout to help prevent vibration
• High-temperature grease supports joint durability under load
• Neoprene boots resist environmental stress and cracking

Product Details

Cardone’s CV axle remanufacturing process uses controlled grinding and inspection methods to preserve the original geometry of the outer housing, race, and cage. That helps maintain proper grease flow through the joint and supports smooth operation. Each shaft is individually checked for straightness, which is important for reducing vibration at speed in Jeep Grand Cherokee and Jeep Grand Wagoneer driveline service.

This part cross-references Jeep 4720381 for the same application.

Common Problems This Part Can Address

• Clicking or snapping during hard turns and acceleration
• Grease leakage from a ruptured outer CV boot
• Front-end vibration caused by a worn or bent axle shaft
• Grinding noise from a damaged outer CV joint
• ABS warning light issues related to axle sensor ring damage or mismatch

Installation Notes

• Do not let the CV axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench on the retaining nut and follow manufacturer torque specifications.
• Do not reuse a prevailing-torque lock nut; install a new nut.
• Replace transaxle seals when installing a new CV drive axle to help prevent leaks.
• Inspect the hub, sensor ring, and nearby wiring before installation to avoid ABS faults.

Quality Assurance

Cardone remanufactures this axle with verified shaft straightness, controlled boot sealing, and inspected joint geometry to support consistent driveline performance. The process also reduces energy and raw material use compared with producing a new part.