Cardone 60-5284 CV Axle Assembly - Front Right

Cardone CV Axle Assembly for Scion xD

Restore smooth power transfer with this remanufactured Cardone CV axle assembly, part number 60-5284. It is built for the front right position on 2008-2014 Scion xD models and is engineered for OE-style fit and vibration-free operation.

Key Features

• Fits 2008-2014 Scion xD, front right
• Remanufactured Original Equipment-style CV axle assembly
• Part number 60-5284
• 20-spline input shaft and 26-spline output shaft
• Stake-style axle nut locking type
• Spindle nut included with M22 x 1.5 thread size
• Compressed length: 35.75 in.
• No ABS ring included
• Boot clamps are pneumatically crimped for a tight seal
• Shafts are checked for straightness and runout to reduce vibration

Product Details

Cardone remanufactures CV drive axles using controlled processes that focus on seal integrity, joint geometry, and shaft straightness. The boot-to-housing seal is formed with pneumatic clamping equipment to help keep grease in and contaminants out, while the internal ball groove geometry is maintained to support proper grease flow and longer service life. High-temperature grease, neoprene boots, and precision grinding of the housing, race, and cage help the assembly perform consistently in daily driving.

This Cardone CV axle assembly 60-5284 is a direct-fit driveline replacement for the front right side of the Scion xD. It is also listed as a cross-reference to Scion 4341052250 for the same application.

Common Problems This Part Can Address

• Clicking or snapping noises during hard turns and acceleration
• Grease leakage around the axle boot or suspension area
• Vibration during acceleration caused by axle runout or wear
• Grinding or popping from a worn outer CV joint
• Driveline shudder from a damaged or contaminated axle assembly

Installation Notes and Tips

Fits 2008-2014 Scion xD, front right. Do not let the axle hang unsupported during service, as this can damage the inner joint. Always replace the old prevailing-torque axle nut with a new nut and tighten it with a torque wrench to the manufacturer specification; do not use an impact wrench for final installation. When replacing CV drive axle assemblies, install new transaxle seals to help prevent leaks. If the ABS warning light appears after installation, inspect the sensor ring, sensor, and nearby wiring for damage.

Quality Assurance

Cardone draws on more than three decades of CV axle remanufacturing experience, with 100% runout inspection to help ensure shafts meet specification before assembly. The remanufacturing process also reduces raw material and energy use compared with producing a new part.