Cardone 60-6246 CV Axle Assembly - Front Right

Remanufactured CV Axle for Nissan Murano

Cardone 60-6246 is a remanufactured CV axle assembly for the front right position on 2003-2007 Nissan Murano models. It is built for direct OE-style fitment and vibration-free operation, with attention to boot sealing, joint geometry, and shaft straightness.

Key Features

• Fits 2003-2007 Nissan Murano, front right
• Remanufactured Original Equipment part for correct vehicle fit
• Pneumatically crimped boot clamps create a tight seal at the boot and housing
• Precision-maintained ball groove geometry supports proper grease flow and joint life
• Shafts are individually checked for straightness and runout to reduce vibration
• High-temperature, high-pressure grease helps protect the CV joints under load
• Neoprene boots provide strong resistance to environmental stress and cracking
• Part number 60-6246 cross-references Nissan 39100CA000 and 39100CA001 for the same application

Product Details

This Cardone CV axle assembly is engineered for the Nissan Murano front right driveline position and is remanufactured to restore smooth power transfer from the transaxle to the wheel. Cardone’s CV axle remanufacturing process focuses on preserving the original housing, race, and cage design while verifying shaft straightness for stable performance at speed. The result is a replacement axle assembly that addresses common wear points without changing the vehicle’s OE fitment characteristics. Part number 60-6246 is a practical choice for Murano owners needing a front right CV axle assembly with OE-style dimensions and spline connection design.

Common Problems This Part Can Address

• Clicking or snapping noises during hard turns and acceleration
• Grease leakage around a torn outer CV boot
• Front-end vibration caused by axle runout or shaft distortion
• Grinding or popping from a worn outer CV joint
• ABS warning issues caused by damaged sensor components during axle service

Installation Notes and Tips

• Fits 2003-2007 Nissan Murano, front right
• Do not let the axle hang unsupported during service; unsupported hanging can damage the inner joint
• Use a torque wrench on the retaining nut and tighten to manufacturer specifications
• Do not reuse a prevailing-torque lock nut; install a new nut during reassembly
• Replace transaxle seals when servicing CV axle assemblies to help prevent leaks
• Inspect the hub, sensor ring, and nearby wiring before installation to avoid ABS faults

Quality Assurance

Cardone remanufactures CV drive axles with controlled sealing, runout inspection, and precision grinding processes to support consistent fit and performance. The brand’s remanufacturing approach also reduces raw material and energy use compared with producing a new part.