Cardone 60-7108 CV Axle Assembly - Front Left

Cardone 60-7108 CV Axle Assembly

The Cardone 60-7108 is a remanufactured CV axle assembly for front left applications on select Audi and Volkswagen models. It is built for OE-style fit, stable driveline operation, and vibration control in demanding daily driving conditions.

Fits 1983-1987 Audi 4000, front left; 1983-1987 Audi Coupe, front left; 1984-1988 Volkswagen Quantum, front left.

Key Features

• Remanufactured Original Equipment part for direct vehicle fit
• Boot clamps are pneumatically crimped to help create a tight seal at the boot and housing
• Shafts are inspected for runout to reduce vibration
• High-temperature, high-pressure grease supports joint durability
• Neoprene boots resist environmental stress and cracking
• Output shaft connection style: spline
• Input shaft connection style: bolt-on with 6 bolt count
• Spindle nut included; self-lock axle nut style; M20x1.5 thread size
• Compressed length: 25.375 in
• No ABS ring included

Product Details

Cardone remanufactured CV axle assemblies are re-engineered with controlled grinding and inspection processes to preserve the original geometry of the outer housing, race, and cage. That helps maintain proper grease flow through the joint and supports smoother operation over time. The 60-7108 is a practical replacement for Audi 4000, Audi Coupe, and Volkswagen Quantum front left driveline service where a worn axle, damaged boot, or vibration issue has affected performance.

This part cross-references Audi 321407271AR and Volkswagen 321407271AR for the same application.

Common Problems This Part Can Address

• Clicking or snapping noise during hard turns and acceleration
• Grease leakage from a ruptured outer CV boot
• Front-end vibration caused by axle runout or shaft wear
• Grinding noise from the driveline with visible joint contamination
• Wobble or thump during acceleration from a worn CV joint

Installation Notes

• Do not let the axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench on the retaining nut and tighten to manufacturer specifications.
• Do not reuse a prevailing-torque lock nut; install a new nut during service.
• Replace transaxle seals when servicing CV axle assemblies to help prevent leaks.
• If the ABS light is on after installation, inspect the sensor ring, sensor, and nearby wiring for damage.

Quality Assurance

Each shaft is individually verified for straightness, and Cardone’s remanufacturing process is focused on consistent OE-style performance and reduced material use versus producing a new part. The result is a remanufactured CV axle assembly built with attention to fit, seal integrity, and vibration control.