Cardone 60-8192 CV Axle Assembly - Front Left

Remanufactured Front Left CV Axle for Mazda CX-7 and CX-9

Cardone 60-8192 is a remanufactured CV axle assembly built for front left applications on select Mazda CX-7 and Mazda CX-9 models. It is engineered for OE-style fit and vibration-free operation, with attention to boot sealing, grease flow, and shaft straightness.

For drivers searching for a Mazda CX-9 front left CV axle assembly or a Mazda CX-7 front left replacement axle, this part number 60-8192 provides a direct driveline service solution.

• Remanufactured Original Equipment part for proper vehicle fit
• Fits 2007-2015 Mazda CX-9, front left
• Fits 2007-2012 Mazda CX-7, front left
• ABS ring included with 44-tooth count
• Stake-style axle nut locking type
• Compressed length: 25.1875 in.
• Spline input and output shaft connections
• Spindle nut included; M24x1.5 thread size
• Package contents: complete axle and instruction sheet

Built for Driveline Performance

Cardone’s CV axle remanufacturing process focuses on the details that affect driveline smoothness and joint life. The boot clamps are pneumatically crimped to form a tight seal between the boot and housing, helping keep grease in and contaminants out. The axle shaft is checked for straightness to reduce vibration, while the joint geometry is maintained to support proper grease circulation. The result is a remanufactured CV axle assembly designed for Mazda CX-7 and Mazda CX-9 front left service where consistent rotation and quiet operation matter.

This part cross-references Mazda OE numbers such as GP312560XA and GP322560X for the same application.

Common Problems This Axle Can Address

• Clicking or snapping noises during turns
• Grease leakage around a torn outer CV boot
• Front-end vibration during acceleration
• Grinding or roughness from a worn CV joint
• ABS warning light caused by a damaged axle ring or sensor-related issue during replacement

Installation Notes and Tips

• Fits 2007-2015 Mazda CX-9, front left, and 2007-2012 Mazda CX-7, front left.
• Do not let the axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench on the retaining nut and follow manufacturer specifications.
• Replace the old prevailing-torque nut rather than reusing it.
• Install new transaxle seals when replacing CV drive axle assemblies to help prevent leaks.
• Inspect the ABS ring, sensor, and nearby wiring during installation to avoid an ABS fault.

Quality Assurance

Cardone remanufactures CV drive axles with 100% run-out inspection to help prevent vibration, and each shaft is verified for straightness before use. The process also uses high-temperature, pressure-resistant grease and neoprene boots for environmental durability. Cardone’s remanufacturing approach reduces raw material and energy use compared with producing a new part.