Cardone 65-2033 Drive Shaft - Rear

Remanufactured Driveshaft for Rear-Drive Ford and Mercury

Cardone 65-2033 is a remanufactured driveshaft / prop shaft built for rear-wheel-drive applications that demand smooth rotation and stable highway performance. It is engineered for 2003-2011 Ford Crown Victoria and 2003-2011 Mercury Grand Marquis rear applications, with dynamic balancing to reduce vibration at speed.

Key Features

• Remanufactured Cardone driveshaft / prop shaft for rear driveline service
• Fits 2003-2011 Ford Crown Victoria, rear
• Fits 2003-2011 Mercury Grand Marquis, rear
• Steel shaft construction with a 3.50 in. / 89.00 mm shaft diameter
• Bolt-on end at one side and slip yoke at the other
• Pre-greased with universal joints included
• Phased and 100% dynamically balanced for smooth operation
• Part number 65-2033 for direct identification

Product Details

Cardone’s remanufactured prop shaft line focuses on restoring driveline function with attention to critical wear points and balance. For this application, the shaft uses steel construction, a universal-joint design, and a slip yoke configuration to match the rear driveline layout used in the Ford Crown Victoria and Mercury Grand Marquis. The compressed length is 64.65 in. (1642.00 mm), and the assembly is pre-greased for service-ready installation. Cardone 65-2033 is also dynamically balanced to help maintain vibration-free performance across a wide range of driving speeds.

This part cross-references OE numbers 3W7Z4602DA and 5W7Z4602A for the same application.

Common Driveline Issues This Part Addresses

• Driveline vibration at highway speeds
• Clunking or shudder during acceleration
• Worn universal joints in the rear driveshaft assembly
• Noise from an out-of-balance prop shaft
• Loss of smooth power transfer from transmission to rear axle

Installation Notes and Tips

Verify rear application, shaft length, end style, and slip yoke configuration before installation. Inspect companion flange, transmission output area, and rear axle connection points for wear or damage before mounting the replacement shaft. Because this assembly is phased and balanced, install it in the correct orientation and confirm driveline angles after service. Part number 65-2033 should be matched to the vehicle’s original driveline configuration for proper fitment.

Quality Assurance

Cardone remanufactured driveshafts are processed through controlled quality checks, with critical components tested for proper function before release. The design is reviewed for potential improvements over the original part where applicable, and each shaft is dynamically balanced to support smooth operation in the Ford Crown Victoria and Mercury Grand Marquis rear driveline applications.