Cardone 65-6016 Drive Shaft - Rear

Remanufactured Driveshaft for Frontier and Equator

The Cardone 65-6016 remanufactured driveshaft is built for rear driveline service on select Nissan Frontier and Suzuki Equator applications. It is engineered for smooth operation, with critical components tested and the assembly dynamically balanced for reduced vibration at speed.

Cardone’s remanufactured prop shaft line focuses on restoring driveline performance with attention to original design details and, where applicable, design improvements for added durability. This makes the 65-6016 a practical replacement for drivers looking for a steel rear driveshaft with service-ready features.

Key Features

• Remanufactured rear driveshaft / prop shaft
• Fits 2005-2019 Nissan Frontier, rear
• Fits 2009-2012 Suzuki Equator, rear
• Steel shaft construction
• Compressed length: 75.98 in. / 1930.00 mm
• Bolt-on end at one side and slip yoke at the other
• Pre-greased with grease fitting included
• Universal joints included; CV joints not included
• Phased and 100% dynamically balanced
• Greasable design

Detailed Description

Cardone Part Number 65-6016 is a remanufactured drive shaft designed for rear-position driveline replacement on the Nissan Frontier and Suzuki Equator. The steel shaft uses a universal-joint design with a bolt-on end and slip yoke end, along with pre-greased service points and included grease fitting for maintenance access. The assembly is phased and dynamically balanced to help maintain smooth driveline rotation and reduce vibration concerns associated with worn or out-of-balance shafts.

This part cross-references Nissan OE numbers 37000EA411 and 37000ZL46A for the same application.

What It Helps Address

• Driveline vibration at highway speeds
• Clunking or looseness from worn universal joints
• Noise from an out-of-balance rear prop shaft
• Wear-related driveline instability in rear-wheel applications
• Replacement needs for a damaged or corroded driveshaft

Installation Notes and Tips

Verify rear-position fitment before ordering and confirm the compressed length, end types, and slip yoke configuration match the original shaft. Inspect companion flange, yoke, and mounting points for wear before installation. After installation, check driveline alignment and road-test the vehicle to confirm smooth operation.

Quality Assurance

Cardone remanufactured prop shafts are produced under stringent quality processes, with critical components tested for proper function. Each assembly is dynamically balanced to support vibration-free performance across a wide range of driving conditions.