Cardone 65-9642 Drive Shaft - Rear

Cardone 65-9642 Drive Shaft for 1989 Ford Ranger

The Cardone 65-9642 drive shaft is a remanufactured rear prop shaft engineered for OE-style form, fit, and function. It is built for the 1989 Ford Ranger with the specified 40-1/2 in. length and short wheelbase application, helping restore driveline performance with balanced operation.

Key Features

• Remanufactured steel drive shaft for rear driveline service
• Built to match OE form, fit, and function
• 100% dynamically balanced at 3200 RPM for vibration-free operation
• Lubricated slip yokes help prevent premature wear
• Greasable design supports serviceability
• 2.5 in. tubing outer diameter for the specified application

Product Details

Cardone Driveshaft / Prop Shaft part number 65-9642 is engineered from extensive prop shaft testing and material analysis to deliver consistent driveline performance. This steel rear drive shaft measures 40-1/2 in. (1028.7 mm), with measurement taken from the end of the flange to the center of the U-joint on the opposite side. For 1989 Ford Ranger rear applications, this part number 65-9642 is the correct OE-style replacement when the vehicle uses the listed short wheelbase configuration.

The Cardone driveshaft line focuses on restoring original driveline geometry and balance, which is important for reducing vibration, protecting joints, and maintaining smooth power transfer. If you are searching for a 1989 Ford Ranger rear drive shaft, Cardone 65-9642 provides a remanufactured solution built around the original application requirements.

Common Problems This Part Can Address

• Driveline vibration at speed
• Worn slip yoke movement or wear-related noise
• Loss of smooth power transfer to the rear axle
• U-joint stress caused by imbalance
• Fitment issues from an incorrect shaft length

Installation Notes and Tips

Verify the measurement method before ordering: this shaft is measured from the end of the flange to the center of the U-joint on the opposite side. Confirm the 40-1/2 in. length, rear position, and short wheelbase configuration on your 1989 Ford Ranger before installation. Inspect related driveline components, including U-joints, flange surfaces, and mounting points, so the replacement shaft can be installed on a clean, properly aligned driveline.

Quality Assurance

Cardone engineers and tests its prop shafts to match OE performance, and each unit is dynamically balanced for vibration-free operation at speed. The remanufactured construction and lubricated slip yokes support long-term driveline service in the specified Ford Ranger application.