Cardone 66-1299 CV Axle Assembly - Front Left or Front Right

CV Axle Assembly for Front Right Applications

Cardone 66-1299 is a new CV axle assembly engineered for front right driveline service on select Chevrolet, Oldsmobile, and Pontiac vehicles. It is built to address common causes of CV joint and boot failure while delivering smooth, vibration-free operation.

This Cardone CV Axle Assembly line focuses on OE-style performance with attention to boot durability, seal life, and shaft straightness. For shoppers searching for a front right CV axle for 1991-1996 Chevrolet Cavalier, Pontiac Grand Am, Pontiac Sunbird, Oldsmobile Achieva, Chevrolet Corsica, or Oldsmobile Cutlass Calais, part number 66-1299 is a direct-fit option for the listed applications.

Key Features

• New CV axle assembly for front right installation
• ABS ring included with 48 teeth
• Splined input shaft, 34 spline count
• Splined output shaft, 33 spline count
• Castle-style axle nut locking type
• Spindle nut included with M20 x 1.5 thread size
• Neoprene boots with added bellows where needed to reduce stress and ozone cracking
• Boot clamps are pneumatically crimped for a secure seal
• High-temperature, high-torque grease for demanding driveline conditions
• Shafts are individually verified for straightness to support smooth operation

Product Details

Cardone 66-1299 is part of the CV Axle Assembly product line, built around engineering methods developed from CV drive axle testing and failure analysis. The design addresses common repeat-failure points such as boot cracking, grease loss, contamination, and shaft runout. Transmission seal diameter is precision-machined after heat treatment to help promote proper sealing and long service life.

This part cross-references Chevrolet 26018511 and 26018513 for the same application. It is a strong match for front right driveline repair on 1991-1996 Chevrolet Cavalier, 1992-1993 Chevrolet Corsica, 1991 Oldsmobile Cutlass Calais, 1992-1995 Oldsmobile Achieva, 1991-1995 Pontiac Grand Am, and 1992-1994 Pontiac Sunbird.

Common Problems This Part Can Address

• Clicking or snapping noise during hard turns and acceleration
• Grease on the chassis or suspension from a ruptured outer boot
• Vibration under load caused by axle runout or shaft imbalance
• Grinding or binding from a worn outer or inner CV joint
• ABS warning light issues after axle replacement when the sensor ring or wiring is damaged

Installation Notes

• Do not let the CV axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench on the retaining nut and tighten to the vehicle manufacturer’s specification.
• Do not reuse a prevailing-torque lock nut; install a new nut during service.
• Replace transaxle seals when installing CV axle assemblies to help prevent leaks.
• Inspect the ABS sensor, ring, and wiring during installation to avoid speed-signal faults.

Quality Assurance

Cardone applies CV axle testing and engineering practices aimed at OE-level performance. Each shaft is checked for straightness, and the assembly uses materials and sealing details selected to reduce common failure modes in driveline service.