Cardone 66-1346 CV Axle Assembly - Front Right

CV Axle Assembly for Front Right Applications

Cardone 66-1346 is a new CV axle assembly engineered for front right driveline service on select 2002-2004 Oldsmobile Silhouette and 2002-2004 Pontiac Montana models. It is built to address common CV failure points with verified shaft straightness, improved boot design, and a complete axle configuration for a direct replacement service.

Key Features

• Fits 2002-2004 Oldsmobile Silhouette, front right
• Fits 2002-2004 Pontiac Montana, front right
• ABS ring included for proper wheel speed signal operation
• Self-lock axle nut style with spindle nut included
• Splined input shaft, 34 spline count
• Splined output shaft, 33 spline count
• Neoprene boots with added bellows where needed to reduce stress and cracking
• High-temperature, high-torque grease for driveline durability
• Boot clamps are pneumatically crimped for a secure seal
• Transmission seal diameter is precision-machined after heat treatment for seal life

Product Details

Cardone CV axle assemblies are engineered from testing and failure analysis of original CV components. The 66-1346 uses design updates aimed at reducing repeat boot and joint failures, including reinforced neoprene boot construction and individually verified shaft straightness for smoother operation. This part cross-references Chevrolet 26093721 and Pontiac 26093721 for the same application.

Common Problems This Part Can Address

• Clicking or snapping during turns from a worn outer CV joint
• Grease leakage around the axle boot from boot rupture or cracking
• Vibration during acceleration caused by axle runout or shaft distortion
• ABS warning light issues after axle replacement when the sensor ring is not correct
• Grinding or clunking from the front end related to CV joint wear

Installation Notes

• Do not let the axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench on the retaining nut and tighten to the vehicle manufacturer’s specification.
• Do not reuse a prevailing-torque lock nut; install the supplied new spindle nut.
• Replace transaxle seals when servicing CV axle assemblies to help prevent leaks.
• Inspect the ABS sensor, wiring, and ring during installation to avoid speed signal faults.

Quality Assurance

Cardone’s CV axle engineering is based on testing original failures and refining the replacement design to improve durability and fit. Each shaft is checked for straightness to help deliver vibration-free performance at speed. Part number 66-1346 is a new assembly supplied with an instruction sheet for service support.