Cardone 66-1451 CV Axle Assembly - Front Right

Cardone CV Axle Assembly 66-1451

Cardone CV Axle Assembly 66-1451 is a new front right driveline replacement for select Chevrolet Aveo and Aveo5 models, plus Pontiac G3, G3 Wave, Wave, and Wave5 applications. It is engineered for OE-level performance with attention to boot durability, shaft straightness, and seal fit.

Key Features

• Fits front right applications on 2004-2011 Chevrolet Aveo, 2006-2011 Chevrolet Aveo5, 2009 Pontiac G3, 2009 Pontiac G3 Wave, 2005-2008 Pontiac Wave, and 2005-2007 Pontiac Wave5
• ABS ring included with 47 teeth for proper wheel speed signal operation
• New axle retaining nut and spindle nut included for service replacement
• Self-lock axle nut style with M20 x 1.5 spindle nut thread size
• Splined input and output connections with 34 input splines and 22 output splines
• Neoprene boot design with added bellows where needed to reduce stress and ozone cracking
• High-temperature, high-torque grease for driveline durability
• Shafts verified for straightness to help reduce vibration at speed

Product Details

Cardone builds this CV axle assembly around the failure points commonly seen in original driveline components. The boot design focuses on resisting cracking and bellows stress, while the shaft is checked for runout to support smooth operation. Precision-machined seal surfaces and pneumatically crimped boot clamps help promote a secure fit and long service life. This part number, 66-1451, is a direct replacement choice for drivers servicing a Chevrolet Aveo front right CV axle or a Pontiac G3 front right axle assembly.

This part cross-references Chevrolet 96348791 and Pontiac 96348791 for the same application.

Common Problems This Part Can Address

• Clicking or snapping noise during hard turns and acceleration
• Grease leakage around the axle boot or underbody
• Front-end vibration caused by axle runout or shaft imbalance
• ABS warning light triggered by a damaged sensor ring or related axle hardware
• Grinding noise from a worn outer CV joint

Installation Notes

Install new transaxle seals when replacing CV drive axle assemblies to help prevent leaks. Do not let the axle hang unsupported during service, and do not reuse a prevailing-torque lock nut. Use a torque wrench to tighten the retaining nut to the vehicle manufacturer’s specification; do not use an impact wrench for final installation. If the old axle was difficult to remove from the hub, inspect the hub and surrounding components for corrosion or damage before reassembly.

Quality Assurance

Cardone uses engineering and testing methods developed from CV axle failure analysis to improve durability and fit. Each shaft is individually checked for straightness, and the assembly is built to support vibration-free performance across the speed range. Part number 66-1451 is a new component designed for dependable service in the listed Chevrolet and Pontiac applications.