Cardone 66-2074 CV Axle Assembly - Front Right

Cardone CV Axle Assembly for Aspire Front Right

Cardone CV Axle Assembly 66-2074 is a new front right driveline replacement for 1994-1997 Ford Aspire applications. Built for direct-fit service, it addresses common CV axle wear concerns with a straightness-verified shaft, sealed boot design, and the correct spline and ABS details for the listed vehicle fitment.

Key Features

• Fits 1994-1997 Ford Aspire, front right
• ABS ring included with 44 teeth
• Splined input shaft, 22 spline count
• Splined output shaft, 24 spline count
• Stake-style axle nut locking type
• Compressed length: 34.75 in.
• Spindle nut included; M20 x 1.5 thread size
• New axle retaining nut supplied for installation
• Neoprene boot design with added bellows where needed to reduce stress and cracking
• Boot clamps are pneumatically crimped for a secure seal
• High-temperature, high-torque grease included for long service life

Product Details

Cardone engineers its CV Drive Axle assemblies around the failure points commonly seen in original units, including boot cracking, grease loss, contamination, and vibration from shaft runout. Each shaft is individually checked for straightness to help deliver smooth operation at all speeds. For Ford Aspire owners searching for a front right CV axle assembly, part number 66-2074 provides the correct fitment details and the OE-style service characteristics needed for a proper repair. This part cross-references Ford F4BZ3B436B for the same application.

Common Problems This Part Can Address

• Clicking or snapping noises during turns from a worn outer CV joint
• Grease on the chassis or suspension from a ruptured axle boot
• Vibration during acceleration caused by axle runout or shaft damage
• ABS warning light issues after axle replacement when the sensor ring is not correct
• Grinding or binding from a damaged CV joint or contaminated axle assembly

Installation Notes and Tips

• Fits 1994-1997 Ford Aspire, front right only.
• Do not let the CV axle hang unsupported during service; support the shaft to avoid joint damage.
• Use a torque wrench on the retaining nut and tighten to the manufacturer specification.
• Do not reuse a prevailing-torque lock nut; replace it with the supplied nut.
• Install new transaxle seals when replacing CV drive axle assemblies to help prevent leaks.
• Inspect the ABS sensor, wiring, and ring during installation to avoid an erratic speed signal.

Quality Assurance

Cardone’s CV axle engineering process focuses on reducing repeat failure by addressing boot durability, seal life, and shaft straightness. Part number 66-2074 is a new assembly built for the listed Ford Aspire fitment and verified for driveline service requirements.