Cardone 66-2176 CV Axle Assembly - Front Left

Cardone CV Axle Assembly for Jaguar X-Type

Cardone CV Axle Assembly 66-2176 is a new driveline replacement for the front left position on 2002-2008 Jaguar X-Type models. Built for direct-fit service, it addresses common CV axle wear concerns with a design focused on seal integrity, shaft straightness, and smooth operation.

Key Features

• Fits 2002-2008 Jaguar X-Type, front left
• New axle retaining nut supplied for installation convenience
• ABS ring included for proper wheel speed signal function
• Self-lock axle nut locking type
• Compressed length: 24.75 in.
• 26-spline input shaft and 27-spline output shaft
• Neoprene boots with added bellows where needed to reduce stress and ozone cracking
• High-temperature, high-torque grease for driveline durability
• Pneumatically crimped boot clamps for a secure boot-to-housing seal
• Precision-machined transmission seal diameter after heat treatment

Product Details

Cardone 66-2176 is engineered from the company’s CV axle testing and remanufacturing experience to address common failure points found in original drive axles. The shaft is individually checked for straightness to help reduce vibration, while the boot design and sealing details are built to support long-term service in demanding driveline conditions. This part cross-references Jaguar C2S29731 for the same application.

For Jaguar X-Type front left axle replacement, this assembly provides the correct spline counts, ABS ring inclusion, and direct-fit dimensions needed for a clean service repair. It is a practical choice when replacing a worn or noisy CV axle on 2002-2008 Jaguar X-Type vehicles.

Common Problems This Part Can Address

• Clicking or snapping noises during hard turns
• Grease leakage from a torn or cracked CV boot
• Front-end vibration caused by axle runout or shaft wear
• ABS warning light issues after axle replacement when the sensor ring is damaged or missing
• Grinding or clunking from a worn outer or inner CV joint

Installation Notes

• Do not let the CV axle hang unsupported during service; this can damage the inner joint
• Use a torque wrench on the retaining nut and tighten to manufacturer specifications
• Do not reuse a prevailing-torque lock nut; install the new nut supplied with the axle
• Replace transaxle seals when servicing CV drive axles to help prevent leaks
• Inspect the ABS sensor, wiring, and ring during installation to avoid speed signal faults

Quality Assurance

Cardone designs its CV drive axles to meet or exceed original equipment performance targets through application-specific engineering and inspection. Shafts are verified for straightness to support vibration-free operation, and sealing components are built to help reduce repeat failure from boot cracking and leakage.