Cardone 66-2310 CV Axle Assembly - Front Right

Cardone CV Axle Assembly for Focus

Cardone CV Axle Assembly 66-2310 is a new front right driveline replacement for 2013-2018 Ford Focus applications. It is engineered for OE-level performance with attention to shaft straightness, boot durability, and seal integrity for smooth operation in daily driving.

Built for the Ford Focus front right position, this CV axle assembly addresses common wear points found in high-mileage driveline service. The 66-2310 part number is a direct-fit style solution for drivers replacing a noisy, vibrating, or leaking axle on 2013-2018 Ford Focus models.

Key Features

• Fits 2013-2018 Ford Focus, front right
• Cardone CV Axle Assembly, part number 66-2310
• New axle retaining nut supplied for installation
• Self-lock axle nut locking type
• Splined input shaft with 26 splines
• Splined output shaft with 27 splines
• Compressed length: 38.504 in.
• No ABS ring included
• High-temperature grease for demanding torque and heat conditions
• Neoprene boots with added bellows where needed to reduce stress and cracking
• Boot clamps are pneumatically crimped for a secure seal
• Transmission seal diameter is precision-machined after heat treatment

Product Details

Cardone’s CV Drive Axle engineering focuses on the failure points that commonly affect original axles. The boot design uses reinforced bellows when required to help resist ozone cracking and flex fatigue, while each shaft is individually checked for straightness to support vibration-free performance at speed. This makes the 66-2310 a practical replacement for Ford Focus driveline service where smooth engagement and consistent joint operation matter.

This part cross-references Ford BV6Z3B436C for the same application.

Common Problems This Axle Can Address

• Clicking or snapping noises during hard turns
• Grease leakage around the axle boot or suspension area
• Front-end vibration during acceleration
• Grinding or rumbling from a worn CV joint
• Axle-related wobble or binding in the front right driveline

Installation Notes

• Fits 2013-2018 Ford Focus, front right only.
• Do not let the axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench on the retaining nut and tighten to manufacturer specifications.
• Do not reuse a prevailing-torque lock nut; replace it with the supplied new nut.
• Replace transaxle seals when servicing CV axle assemblies to help prevent leaks.
• If the ABS light remains on after installation, inspect the sensor ring, sensor, and nearby wiring for damage.

Quality Assurance

Cardone builds this CV axle assembly using testing and engineering methods developed to meet or exceed OE performance targets. The shaft is verified for straightness, and the boot and seal details are designed to support long-term driveline reliability in Ford Focus service.