Cardone 66-2396 CV Axle Assembly - Rear Left or Rear Right

Cardone CV Axle Assembly for Ford Fusion

Cardone 66-2396 is a new CV axle assembly engineered for rear axle service on the 2013 Ford Fusion. It is built to deliver smooth power transfer, stable operation, and OE-style fitment for rear left or rear right applications.

Key Features

• Fits 2013 Ford Fusion, rear right
• Fits 2013 Ford Fusion, rear left
• New CV axle assembly for driveline and axle repair
• Splined input shaft with 25 splines
• Splined output shaft with 27 splines
• Self-lock axle nut style with spindle nut included
• No ABS ring included
• Compressed length: 820 in
• Package contents: complete axle and instruction sheet

Built for OE-Style Performance

Cardone applies extensive CV axle testing and engineering to address common failure points found in original units. The axle shaft is individually checked for straightness to help reduce vibration, while the boot design uses neoprene construction with added bellows where needed to resist stress and ozone cracking. High-temperature, high-torque grease and pneumatically crimped boot clamps support long-term joint protection and sealing. Cardone 66-2396 is a direct-fit driveline replacement for the Ford Fusion rear axle position.

This part cross-references Ford DG9Z4K138AB for the same application.

Common Problems This Part Can Address

• Clicking or snapping noises during turns
• Grease leakage around the axle boot or suspension
• Vibration during acceleration
• Grinding or rumbling from the rear driveline area
• Axle-related noise after boot or joint wear

Installation Notes and Tips

Do not let the CV axle hang unsupported during service, as this can damage the inner joint. Always install a new axle nut and torque it to the manufacturer specification with a torque wrench; do not use an impact wrench for final tightening. When replacing CV drive axle assemblies, install new transaxle seals to help prevent leaks. If the ABS warning light appears after installation, inspect the sensor ring, sensor, and nearby wiring for damage.

Quality Assurance

Cardone’s CV axle manufacturing process includes runout verification to help control vibration and maintain straight shaft performance. The design focus is on reducing repeat failure by addressing boot cracking, seal wear, and joint contamination concerns commonly seen in driveline service.