Cardone 66-3056 CV Axle Assembly - Front Right

CV Axle Assembly for Neon Front Right

Cardone 66-3056 is a new CV axle assembly engineered for front right service on select Dodge Neon and Plymouth Neon models. It is built to address common axle failure points with verified shaft straightness, durable boot design, and a complete axle configuration for direct replacement service.

Key Features

• Fits 1995-1999 Dodge Neon, front right
• Fits 1995-1999 Plymouth Neon, front right
• ABS ring included with 56 teeth
• Self-lock axle nut locking type
• Compressed length: 37.0625 in.
• Splined input shaft with 25 splines
• Splined output shaft with 23 splines
• Spindle nut included
• Package contents: complete axle and instruction sheet
• Neoprene boot design with added bellows where needed to reduce stress and ozone cracking
• High-temperature, high-torque grease for demanding driveline service
• Boot clamps are pneumatically crimped for a secure seal

Product Details

Cardone CV Axle Assembly 66-3056 is part of the brand’s CV Drive Axle line, which focuses on correcting common causes of repeat failure in driveline service. Shafts are individually checked for straightness to help reduce vibration, and the transmission seal diameter is precision-machined after heat treatment to support proper sealing and long service life. This part cross-references Dodge and Plymouth OE numbers such as 4668700 and 4668800AB for the same application.

Common Problems This Part Can Address

• Clicking or snapping noises during hard turns and acceleration
• Grease leakage around the axle boot or underbody
• Front-end vibration caused by a worn or bent axle shaft
• ABS warning light issues related to a damaged sensor ring or axle-side sensor components
• Grinding or thumping from a worn outer or inner CV joint

Installation Notes

• Fits 1995-1999 Dodge Neon, front right.
• Fits 1995-1999 Plymouth Neon, front right.
• Do not let the axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench to install the retaining nut to the manufacturer’s specification.
• Do not reuse a prevailing-torque lock nut; install a new nut.
• Replace transaxle seals when servicing CV axle assemblies to help prevent leaks.
• If the ABS light remains on after installation, inspect the sensor ring, sensor, and nearby wiring for damage.

Quality Assurance

Cardone engineers and tests CV drive axles to meet or exceed original equipment performance targets. Each shaft is verified for straightness, and the boot and seal design are built to support consistent driveline operation in daily driving conditions.