Cardone 66-3087 CV Axle Assembly - Front Left

Cardone 66-3087 CV Axle Assembly

Cardone 66-3087 is a new front left CV axle assembly engineered for direct replacement in select Chrysler, Dodge, and Plymouth applications. It is built with attention to axle straightness, boot durability, and seal integrity to support smooth driveline operation and consistent ABS performance.

Key Features

• New CV axle assembly for the front left position
• ABS ring included with 56 teeth for proper wheel speed signal operation
• Self-lock axle nut style with spindle nut included
• Compressed length: 24.5 in.
• Splined connections: 25-tooth input shaft and 26-tooth output shaft
• Neoprene boots with added bellows where needed to reduce stress and ozone cracking
• Boot clamps are pneumatically crimped for a secure seal
• High-temperature, high-torque grease supports long service life
• Shafts are individually verified for straightness to reduce vibration
• Transmission seal diameter is precision-machined after heat treatment for proper sealing

Product Details

This Cardone CV axle assembly is part of the brand’s CV Drive Axle line, which focuses on OE-style driveline performance through engineering and testing. The design addresses common failure points such as boot cracking, grease loss, and shaft runout, helping maintain stable operation in daily driving conditions. This part cross-references Chrysler 4668733 and 4670211 for the same application. It is a direct replacement for select 1995-2000 Dodge Stratus front left, 1995-1997 Chrysler Cirrus front left, 1996-2000 Plymouth Breeze front left, and 1996-1997 Chrysler Sebring front left applications.

Common Problems This Part Can Address

• Clicking or snapping during hard turns
• Grease on the chassis or suspension from a ruptured outer boot
• Vibration during acceleration caused by axle runout or imbalance
• ABS warning light triggered by a damaged sensor ring or wiring near the axle
• Grinding or clunking from a worn outer CV joint

Installation Notes

• Fits 1995-2000 Dodge Stratus, front left
• Fits 1995-1997 Chrysler Cirrus, front left
• Fits 1996-2000 Plymouth Breeze, front left
• Fits 1996-1997 Chrysler Sebring, front left
• Do not let the axle hang unsupported during service; this can damage the inner joint
• Use a torque wrench on the retaining nut and tighten to the vehicle manufacturer’s specification
• Do not reuse a prevailing-torque lock nut
• Replace transaxle seals when installing a replacement CV drive axle assembly
• Inspect the ABS ring, sensor, and wiring during installation to avoid an ABS fault

Quality Assurance

Cardone engineers and tests CV drive axles to meet or exceed OE performance targets. Each shaft is checked for straightness, and the boot and seal design is intended to reduce repeat failure from common driveline wear points.