Cardone 66-3315 CV Axle Assembly - Front Left

Cardone CV Axle Assembly for Front Left Applications

Cardone CV Axle Assembly 66-3315 is a new front left driveline replacement for select Hyundai Accent and Dodge Verna applications. It is built with a splined 25-tooth input and output connection, an ABS ring included, and a castle-style axle nut locking type for a direct-service replacement.

Key Features

• Fits 2006 Dodge Verna, front left
• Fits 2003-2005 Hyundai Accent, front left
• Fits 2000 Hyundai Accent, front left
• Cardone part number 66-3315
• New axle retaining nut supplied for installation convenience
• ABS ring included for vehicles equipped with wheel speed sensing at the axle
• Neoprene boots use added bellows where needed to reduce stress and ozone cracking
• Boot clamps are pneumatically crimped for a secure seal
• High-temperature, high-torque grease is used for long-term joint lubrication
• Shafts are individually verified for straightness to support vibration-free operation

Product Details

This Cardone CV axle assembly is engineered from the company’s CV driveline testing and remanufacturing experience, with attention to common failure points such as boot cracking, contamination, and shaft runout. The axle shaft is inspected for straightness, and the transmission seal diameter is precision-machined after heat treatment to help promote proper sealing and long service life. Cardone 66-3315 is a practical replacement choice for Hyundai Accent front left CV axle service and Dodge Verna front left axle repair.

This part cross-references Hyundai 4950025300 and Dodge 4950025300 for the same application.

Common Problems This Axle Can Address

• Clicking or snapping noises during turns
• Grease leakage around a torn outer CV boot
• Front-end vibration caused by shaft runout or wear
• ABS warning light concerns related to a damaged sensor ring or axle-mounted sensor area
• Clunking or thumping from a worn CV joint under acceleration

Installation Notes

• Do not let the CV axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench on the axle nut and tighten to the vehicle manufacturer’s specification.
• Do not reuse a prevailing-torque lock nut; install the supplied new nut.
• Replace transaxle seals when removing and installing CV axle assemblies to help prevent leaks.
• Inspect the ABS ring, sensor, and nearby wiring during installation to avoid speed signal issues.

Quality Assurance

Cardone designs this CV axle assembly to meet or exceed original equipment performance targets through application-specific engineering, boot design improvements, and 100% shaft runout verification. The result is a replacement axle built for consistent operation in the listed Hyundai Accent and Dodge Verna front left applications.