Cardone 66-3334 CV Axle Assembly - Front Left

CV Axle Assembly for Front Left Applications

Cardone 66-3334 is a new CV axle assembly engineered for front left driveline service on select Chrysler, Dodge, and Mitsubishi vehicles. It is built with a splined input and output connection, an ABS ring, and a supplied spindle nut for a direct replacement on the listed applications.

Key Features

• Fits 2001-2005 Chrysler Sebring, front left
• Fits 2001-2005 Dodge Stratus, front left
• Fits 2000-2005 Mitsubishi Eclipse, front left
• Fits 1999-2003 Mitsubishi Galant, front left
• ABS ring included with 43 teeth for speed signal operation
• Castle-style axle nut locking type with spindle nut included
• Compressed length: 25.6875 in.
• Input shaft: splined, 27 spline count
• Output shaft: splined, 25 spline count
• New axle retaining nut supplied for installation

Product Details

Cardone CV Axle Assembly 66-3334 is part of the brand’s CV Axle Assembly line, focused on OE-style driveline replacement for front-wheel-drive applications. The axle shaft is individually checked for straightness to help reduce vibration at speed, while the boot design uses additional bellows where needed to resist stress and ozone cracking. High-temperature grease and pneumatically crimped boot clamps support consistent joint sealing and long-term service. This part cross-references Mitsubishi MR357809 and MR410041 for the same application.

Common Problems This Part Can Address

• Clicking or snapping during hard turns and acceleration
• Grease leakage around the axle boot or chassis
• Front-end vibration under load or at highway speed
• ABS warning light caused by a damaged or incorrect sensor ring setup
• Grinding or noise from a worn outer CV joint

Installation Notes

• Do not let the axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench on the retaining nut and tighten to the vehicle manufacturer’s specification.
• Replace the old prevailing-torque nut rather than reusing it.
• Install new transaxle seals when replacing CV axle assemblies to help prevent leaks.
• Inspect the ABS sensor, wiring, and ring during installation to avoid speed-signal faults.

Quality Assurance

Cardone engineers and tests CV drive axles to meet or exceed original equipment performance targets. Each shaft is verified for straightness, and the assembly is built with materials and sealing details chosen to reduce repeat failure in common wear areas.