Cardone 66-3366 CV Axle Assembly - Front Right

Cardone CV Axle Assembly for Hyundai Santa Fe

Restore driveline performance with the Cardone CV Axle Assembly, part number 66-3366, for the front right position on select 2003-2006 Hyundai Santa Fe models. This new CV axle is engineered with attention to straightness, boot durability, and seal fit to support smooth operation and reduced vibration.

Key Features

• Fits 2003-2006 Hyundai Santa Fe, front right
• Cardone CV Axle Assembly, part number 66-3366
• ABS ring included with 52-tooth count
• New axle retaining nut and spindle nut included
• Neoprene boots use added bellows where needed to resist stress and ozone cracking
• Boot clamps are pneumatically crimped for a secure boot-to-housing seal
• High-temperature, high-torque grease is used for long-lasting joint performance
• Shafts are individually verified for straightness to help reduce vibration
• Splined input shaft: 28 spline count; splined output shaft: 27 spline count
• Compressed length: 23.5 in.

Product Details

Cardone’s CV axle engineering focuses on the common causes of original axle failure, including boot cracking, contamination, and vibration. The 66-3366 is built as a new replacement axle for the Hyundai Santa Fe front right application, with an ABS ring, precision-machined seal diameter, and verified shaft straightness to support consistent driveline operation. This part cross-references Hyundai 4950026850 and 4950026860 for the same application.

Common Problems This Part Can Address

• Clicking or snapping noises during turns
• Grease leakage around the axle boot or suspension area
• Front-end vibration during acceleration
• ABS warning light caused by a damaged sensor ring or related axle component
• Grinding or binding from a worn outer or inner CV joint

Installation Notes

Fits 2003-2006 Hyundai Santa Fe, front right. Replace the axle retaining nut rather than reusing the old prevailing-torque nut, and torque fasteners to the vehicle manufacturer’s specification with a torque wrench. Do not let the axle hang unsupported during service, and install new transaxle seals when replacing CV axle assemblies to help prevent leaks. If the ABS light remains on after installation, inspect the sensor ring, sensor, and nearby wiring for damage.

Quality Assurance

Cardone applies testing and engineering methods developed from CV axle remanufacturing experience to help the part meet or exceed original equipment performance targets. Each shaft is checked for straightness, and the axle design addresses known failure points such as boot stress, cracking, and seal wear.