Cardone 66-3410 CV Axle Assembly - Front Right

Cardone CV Axle Assembly 66-3410

Cardone 66-3410 is a new front right CV axle assembly engineered for direct replacement in select Hyundai applications. It is built with a splined 25-tooth input and output connection, an ABS ring with 44 teeth, and a castle-style axle nut setup for a service-ready installation.

Compatible with 1999-2000 Hyundai Elantra, front right, and 2000-2001 Hyundai Tiburon, front right, this CV axle assembly is designed for drivers addressing vibration, clicking, or grease leakage at the front end. The Cardone CV Axle Assembly line focuses on OE-style performance with attention to boot durability, shaft straightness, and seal integrity.

Key Features

• Part number 66-3410 for direct identification
• Front right CV axle assembly for Hyundai Elantra and Hyundai Tiburon applications
• ABS ring included with 44-tooth count
• Splined 25-tooth input and output shaft connections
• New axle retaining nut and spindle nut included
• Neoprene boot design with added bellows where needed to reduce stress and cracking
• High-temperature grease formulated for driveline load and heat
• Shafts individually checked for straightness to help reduce vibration

Product Details

Cardone’s CV Axle Assembly program is built around failure points commonly seen in original drive axles, including boot cracking, grease loss, and shaft runout. For this application, the axle is assembled with a precision-machined transmission seal diameter after heat treatment to support proper sealing, while pneumatically crimped boot clamps help maintain a tight seal between the boot and housing. Cardone 66-3410 is a practical OE-style replacement for front right driveline service on 1999-2000 Hyundai Elantra and 2000-2001 Hyundai Tiburon.

This part cross-references Hyundai 4950829L20 and 4950829M20 for the same application.

Common Problems This Part Can Address

• Clicking or snapping noises during hard turns and acceleration
• Grease on the chassis or suspension from a torn outer boot
• Front-end vibration caused by axle runout or shaft imbalance
• ABS warning light after axle replacement if the sensor ring is damaged or incorrect
• Grinding or binding from a worn outer CV joint

Installation Notes and Tips

• Fits 1999-2000 Hyundai Elantra, front right, and 2000-2001 Hyundai Tiburon, front right.
• Do not let the CV axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench on the retaining nut and tighten to the manufacturer specification.
• Do not reuse a prevailing-torque axle nut; replace it with the supplied nut.
• Install new transaxle seals when replacing CV axle assemblies to help prevent leaks.
• If the ABS light remains on after installation, inspect the sensor ring, sensor, and nearby wiring for damage.

Quality Assurance

Cardone engineers and tests CV drive axles to meet or exceed OE performance targets, with 100% runout inspection on shafts used in remanufacturing and straightness verification on axle shafts to help reduce vibration at speed. The brand’s CV axle design also addresses common boot-failure causes with reinforced neoprene boot construction and secure clamp sealing.