Cardone 66-3414 CV Axle Assembly - Rear Left or Rear Right

Cardone CV Axle Assembly for Montero

Restore driveline performance with the Cardone CV Axle Assembly, part number 66-3414, for select Mitsubishi Montero rear applications. This new axle is engineered for smooth operation, accurate fitment, and dependable transfer of power in 2001-2006 Mitsubishi Montero rear right and rear left positions.

Key Features

• Fits 2001-2006 Mitsubishi Montero, rear right
• Fits 2001-2006 Mitsubishi Montero, rear left
• ABS ring included with 50 teeth for proper speed signal operation
• Castle-style axle nut locking type with spindle nut included
• Compressed length: 26.535 in.
• Output shaft connection style: splined, 33 spline count
• Input shaft connection style: bolt-on
• New axle retaining nut supplied for easier installation
• Boot clamps are pneumatically crimped for a secure seal
• High-temperature, high-torque grease supports long service life

Built for OE-Style Performance

Cardone designs its CV axle assemblies using testing and engineering methods developed to address common failure points found in original units. On this 66-3414 assembly, the neoprene boot design uses added bellows where needed to reduce stress and help resist ozone cracking, while each shaft is individually checked for straightness to support vibration-free operation at speed. This makes the Cardone 66-3414 a practical replacement for Mitsubishi Montero rear axle service when the original axle shows wear, noise, or boot damage.

This part cross-references Mitsubishi MR528647 for the same application.

Common Problems This Axle Can Address

• Clicking or snapping noises during turns
• Grease leakage around the axle boot or suspension area
• Vibration during acceleration or at road speed
• ABS warning light after axle replacement or sensor-ring damage
• Grinding or thumping from a worn rear CV axle assembly

Installation Notes

When replacing a CV axle on a Mitsubishi Montero, do not let the axle hang unsupported during service. Always torque the retaining nut to manufacturer specifications with a torque wrench, and replace the old prevailing-torque nut rather than reusing it. Install new transaxle seals when required to help prevent leaks, and inspect the ABS sensor, wiring, and ring during installation to avoid signal issues.

Quality Assurance

Cardone applies 100% run-out inspection to shafts used in remanufacturing and verifies straightness to reduce vibration concerns. The brand’s CV axle engineering focuses on correcting known failure causes, including boot stress, seal wear, and joint contamination, to support reliable service in rear axle applications for the Mitsubishi Montero.