Cardone 66-3418 CV Axle Assembly - Front Right

Cardone CV Axle Assembly for Jeep Front Right

Cardone CV Axle Assembly 66-3418 is a new front right driveline replacement engineered for select Jeep Commander and Jeep Grand Cherokee applications. It is built to address common CV axle failure points with a straightness-verified shaft, precision sealing surfaces, and boot construction focused on long-term joint protection.

Key Features

• Fits 2006-2010 Jeep Commander, front right
• Fits 2005-2009 Jeep Grand Cherokee, front right
• Fits 2010 Jeep Grand Cherokee, front right
• ABS ring included for proper wheel speed signal operation
• Spindle nut included; axle nut locking type is stake
• Input and output shaft connection style: splined, 29 spline count
• Compressed length: 23.9375 in.
• New axle retaining nut supplied with the unit
• Neoprene boots use added bellows where needed to reduce stress and ozone cracking
• Boot clamps are pneumatically crimped for a secure seal
• High-temperature, high-torque grease is used for joint lubrication

Product Details

Cardone’s CV Axle Assembly line is engineered around the failure modes commonly seen in original CV axles. For this application, part number 66-3418 is built to deliver OE-style fit and function for Jeep Commander and Jeep Grand Cherokee front right service, with attention to boot durability, seal life, and vibration control. Each shaft is individually checked for straightness to help maintain smooth operation at speed, while the precision-machined transmission seal diameter supports proper sealing after heat treatment. This part cross-references Jeep 52104590AA for the same application.

Common Problems This Part Can Address

• Clicking or snapping noise during hard turns and acceleration
• Grease leakage around the axle boot or chassis area
• Front-end vibration caused by a bent or out-of-runout axle shaft
• ABS warning light after axle replacement when the sensor ring is not correct
• Grinding or binding from a worn outer or inner CV joint

Installation Notes and Tips

Use a torque wrench and tighten the retaining nut to the vehicle manufacturer’s specification; do not use an impact wrench for final installation. Do not let the CV axle hang unsupported during service, and replace the old prevailing-torque nut rather than reusing it. When replacing the axle, install new transaxle seals to help prevent leaks. If the ABS light remains on after installation, inspect the sensor ring, sensor, and nearby wiring for damage.

Quality Assurance

Cardone engineers and tests its CV drive axles to meet or exceed original equipment performance targets. The brand’s process includes runout verification for vibration control and boot designs intended to reduce common causes of premature CV failure.