Cardone 66-3453 CV Axle Assembly - Front Right

Cardone CV Axle Assembly 66-3453

Cardone 66-3453 is a new front right CV axle assembly engineered for direct replacement in select Hyundai, Kia, and Dodge applications. It is built around verified shaft straightness, sealed CV joints, and a design approach that addresses common axle failure points for smoother driveline operation.

Key Features

• Fits 2006-2011 Hyundai Accent, front right
• Fits 2006-2012 Kia Rio, front right
• Fits 2006-2011 Kia Rio5, front right
• Fits 2006-2011 Dodge Attitude, front right
• ABS ring included with 48-tooth count
• Castle-style axle nut locking type
• Compressed length: 36.3125 in.
• Splined input and output shaft connection style with 25 splines each
• Spindle nut included
• New axle retaining nut supplied for installation
• Boot clamps are pneumatically crimped for a secure seal
• High-temperature, high-torque grease used for joint protection

Product Details

This Cardone CV axle assembly is designed for OE-style driveline service on the front right side of the vehicle. Cardone’s engineering process focuses on the causes of repeat CV axle failure, including boot cracking, seal leakage, and vibration from shaft runout. Neoprene boots are shaped with added bellows where needed to reduce stress and ozone-related cracking, while each shaft is checked for straightness to help maintain vibration-free performance at speed. This part cross-references Hyundai (e.g., 495001E050, 495001E051) for the same application.

Common Problems This Part Can Address

• Clicking or snapping during hard turns and acceleration
• Grease leakage around the axle boot or suspension area
• Front-end vibration caused by axle runout or shaft imbalance
• ABS warning light after axle replacement when the sensor ring is damaged or incorrect
• Grinding noise from a worn outer CV joint

Installation Notes and Tips

• Do not let the CV axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench on the retaining nut and tighten to the vehicle manufacturer’s specification.
• Do not reuse a prevailing-torque lock nut; install the supplied new nut.
• Replace transaxle seals when servicing the axle to help prevent leaks.
• Inspect the ABS sensor, wiring, and ring during installation to avoid an erratic speed signal.

Quality Assurance

Cardone builds this CV axle assembly using engineering methods developed from testing original axle failure modes. The shaft is individually verified for straightness, and the boot and seal interfaces are designed for durable service under driveline load. Part number 66-3453 is a new component for direct replacement use.