Cardone 66-3486 CV Axle Assembly - Front Left

Cardone CV Axle Assembly for Mitsubishi Endeavor

Cardone 66-3486 is a new CV axle assembly engineered for front left applications on select Mitsubishi Endeavor models. It is built with a splined 28-tooth input shaft, a splined 27-tooth output shaft, and a 43-tooth ABS ring to support proper driveline and wheel-speed sensor operation.

Key Features

• Fits 2004-2008 Mitsubishi Endeavor, front left
• Fits 2010-2011 Mitsubishi Endeavor, front left
• ABS ring included with 43 teeth
• Castle-style axle nut locking type
• Compressed length: 26.62 in.
• Splined input shaft with 28 splines
• Splined output shaft with 27 splines
• New axle retaining nut included
• Spindle nut included
• Package contents: complete axle and instruction sheet

Product Details

Cardone’s CV axle assembly line is engineered from testing and failure analysis of original drive axles, with attention to common wear points such as boot cracking, joint contamination, and vibration from shaft runout. This approach is reflected in the 66-3486 design, which uses neoprene boots with added bellows where needed to reduce stress and ozone-related cracking, plus individually verified shaft straightness for smoother operation. For Mitsubishi Endeavor front left service, Cardone 66-3486 provides a direct driveline replacement built around OE-style fit and function.

This part cross-references Mitsubishi MN147037 and MN147039 for the same application.

Common Problems This Part Can Address

• Clicking or snapping during hard turns
• Grease leakage around the axle boot or chassis
• Front-end vibration during acceleration
• ABS warning light caused by axle sensor ring issues
• Grinding noise from a worn outer CV joint

Installation Notes and Tips

Fits 2004-2008 Mitsubishi Endeavor, front left, and fits 2010-2011 Mitsubishi Endeavor, front left. Do not let the axle hang unsupported during service, as this can damage the inner joint. Replace the axle nut rather than reusing a prevailing-torque style nut, and torque the new nut to the manufacturer specification with a torque wrench. If the transaxle seals are disturbed during removal, install new seals to prevent leaks. Inspect the ABS sensor, wiring, and ring before final assembly to avoid an erratic speed signal.

Quality Assurance

Cardone verifies axle shafts for straightness and runout to help reduce vibration concerns. The design also addresses common CV failure causes with improved boot construction and durable grease formulated for high load and temperature conditions.