Cardone 66-4022 CV Axle Assembly - Front Left

Cardone CV Axle Assembly for Honda Prelude

Restore driveline performance with the Cardone 66-4022 CV axle assembly for the front left position on the 1989 Honda Prelude. This new axle is built with attention to straightness, seal integrity, and joint durability for smooth operation at speed.

Cardone CV axle assemblies are engineered from testing and failure analysis of original units. For the 66-4022 application, that means a replacement axle designed to address common boot, seal, and vibration concerns while maintaining OE-style fitment for the 1989 Honda Prelude, front left.

Key Features

• Fits 1989 Honda Prelude, front left
• Part number 66-4022
• New CV axle assembly with complete axle and instruction sheet
• ABS ring included for proper sensor system operation
• Stake-style axle nut locking type
• Compressed length: 24.25 in.
• Input shaft: splined, 27 spline count
• Output shaft: splined, 26 spline count
• Spindle nut included
• Neoprene boots with added bellows where needed to reduce stress and cracking
• Boot clamps are pneumatically crimped for a secure seal
• High-temperature, high-torque grease supports long service life
• Shafts are individually checked for straightness to reduce vibration

Product Details

The Cardone CV axle assembly 66-4022 is a driveline replacement for the 1989 Honda Prelude front left side. It is engineered to deliver smooth power transfer from the transaxle to the wheel while helping maintain consistent operation under load. Cardone’s CV axle design focuses on the common failure points found in original axles, including boot cracking, grease loss, contamination, and vibration from shaft runout.

This part cross-references Honda 44306SF1914 for the same application. For shoppers searching for a 1989 Honda Prelude front left CV axle assembly, Cardone 66-4022 provides a direct replacement option with ABS ring inclusion and OE-style spline connections.

Common Problems This Part Can Address

• Clicking or snapping noises during turns
• Grease leakage around the axle boot or chassis
• Front-end vibration during acceleration
• Grinding or rough driveline noise from a worn CV joint
• ABS warning light caused by axle sensor ring or wiring damage during replacement

Installation Notes and Tips

• Do not let the CV axle hang unsupported during service; support the shaft to avoid inner joint damage.
• Use a torque wrench on the retaining nut and tighten to the vehicle manufacturer’s specification.
• Do not reuse a prevailing-torque lock nut; install a new nut during service.
• Replace transaxle seals when installing a new CV axle assembly to help prevent leaks.
• Inspect the ABS ring, sensor, and nearby wiring during installation to avoid an ABS fault.

Quality Assurance

Cardone applies testing and engineering methods developed from CV axle failure analysis to improve fit, balance, and durability. Each shaft is verified for straightness to help reduce vibration, and the boot and grease design are selected to support reliable service in demanding driveline conditions.